- Out-of-Stock
Foreword; Introduction: Do not be afraid by the Darker side; Impedance matching basics; Microstrip techniques; Time Domain Reflectometry; Let's play with EMI; Cable shielding experiments; The Fast Fourier Transform from A to Z; No fear with FIR: Put a Finite Impulse Response filter to work; Multirate processing techniques and CIC filters; Let's be crystal clear; Are you locked? A PLL primer; Direct digital synthesis 101; Open your eyes! A primer on high speed signal transmission techniques; Digital modulations demystified; Antenna basics; Low power techniques: Build better energy-saving systems; From powerline measurements to PFC; PID control without math; Linear control basics; Scilab tutorial; Complex numbers 101; References and sources
The eMMC 5.1 flash memory module for Hardkernel Odroid C2 computers. 16GB capacity, Android operating system installed. The set includes a microSD adapter. Hardkernel
No product available!
A module with Acconeer sensor A111. A111 is a one-chip radar (PCR) solution complete with antennas and SPI interface up to 50 MHz. SparkFun Pulsed Radar Breakout A111
No product available!
The special construction of the braid facilitates installation in all conditions. z28419
No product available!
No product available!
No product available!
Stereo tube preamplifier based on 6J3 tubes. Designed for use with active speakers or an additional amplifier and passive speakers
No product available!
No product available!
HK NTM Prop Drive Series 28-30 900kv / 300W Brushless Motor (52858)
No product available!
No product available!
Li-Ion battery type 18650 with a nominal voltage of 3.7 V and a capacity of 3450 mAh. Sanyo NCR18650GA
No product available!
No product available!
Pre-installed Android5.x or latest version. eMMC Version 5.0 interface or higher version from Samsung. JEDEC/MMCA version 5.0 : HS400 interface with 8bit DDR mode. The eMMC chipset is only compatible with Amlogic S905 and S805 series(ODROID-C1+ / C0 / C2)
No product available!
No product available!
No product available!
Starter kit with the Raspberry Pi 3 model A + minicomputer, the kit also includes the official case for RPI 3 model A and a card with pre-installed NOOBS software and a 116-page guide.
No product available!
No product available!