- Out-of-Stock

ANALOGIC-DIGITAL ANALYZER WIDMA - PRINTED PLATES AND PROGRAMMED SYSTEM
The system used to analyze and display the spectrum of the audio signal, very often used (and found) in audio tracks of audiophile equipment from the so-called high shelf. In addition to the analogue part, in the kit, digital signal processing, or DSP, was used. The heart of the analyzer is the ATMega8 processor. The A / C converter included in its structure serves the appropriate conversion of the analogue signal into digital signal and this is directed to the display realized from the series of LED diodes. Filters, thanks to which the appropriate 'posts' light up, have been implemented on the curriculum. This has simplified the design of the analyzer making it possible for even an intermediate electronic designer to build and run it.
The device is particularly recommended for electronics - electroacoustics and audiophiles
Selected parameters:
Download
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
No product available!
Micsig DP series differential probe based on advanced SigOFIT technology. It offers a frequency band of 150 MHz and the ability to measure voltage up to 1500 V. It uses the popular BNC connector and is powered by a USB Type-C connector. Micsig DP1501
No product available!
No product available!
No product available!
MYIR MYC-C7Z010 is a single board module based on the MYC-C7Z010 chip. This system consists of a dual-core processor based on the Cortex-A9 core (667 MHz) and the Artix-7 FPGA chip. The board has 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board is equipped with numerous peripherals, the outputs of which have been led out on two 140-pin connectors.
No product available!
No product available!
Raspberry Pi 3 & MathWorks Learn to Program Pack is a set consisting of a Raspberry Pi 3 computer with necessary hardware and MATLAB & Simulink Student Suite software. The set is designed for modeling and implementing solutions based on Raspberry Pi 3 in MATLAB and SIMULINK environments
No product available!
No product available!
PCB board ICSP programmer for PIC microcontrollers
No product available!
Camera with a monochrome CMOS OV9281 sensor with a resolution of 1280x800 px. Equipped with a snapshot, it communicates via the 2-lane MIPI interface. ArduCAM U6072
No product available!
PCB and programmed layout for the gigatermometer. AVT3155 A +
No product available!
Universal organizer with compartments. Allows you to store small parts and tools. BOX0002
No product available!
No product available!
No product available!
PCB and programmed circuit for the DDS generator for the 1Hz ... 40MHz range with the sweep. AVT5580 A +
No product available!
Assembled 4-channel digital thermometer that allows you to control the temperature in several points at once, in a large temperature range. AVT3085C
No product available!
ANALOGIC-DIGITAL ANALYZER WIDMA - PRINTED PLATES AND PROGRAMMED SYSTEM