- Out-of-Stock
MICROPROCESSOR FREQUENCY METER 100MHZ - PRINTED PLATE
The system is intended as a module for incorporation into any device or as an autonomous device for measuring frequencies from 1 Hz to 100 Mhz. It has a counting event counter built-in up to 64,000. The system provides automatic change of the frequency range measured. The alphanumeric LCD display used guarantees perfect readability of the given results.
The meter was built using the AT90S2313 microprocessor. The meter made using only this system would have a measuring range up to 5MHz. In most cases, hobbyists would consider such a range to be quite sufficient, but a simple prescaler was added to the system, made on two cheap TTL systems. This preskaler expands the measuring range of the meter to 100MHz.
The printed circuit board and documentation are included.
Available version with a set of components for independent use
The exact description of EdW 11/00
Download
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
No product available!
3.5 "TFT display with touch panel, transparent housing and 16 GB SD card for Raspberry Pi 3. ArduCAM U470302
No product available!
Display with a touch screen (resistive panel) with a diagonal of 3.5 inches and a resolution of 480 x 320 pixels. Uses the SPI interface. Intended for use with the Raspberry Pi Zero / B + / 2/3 minicomputer. ArduCAM U470301
No product available!
A set of basic electronic components complete with contact plate, connecting cables and Mega2560 R3. It is ideal for beginner electronics who also know Arduino. ArduCAM KB0003
No product available!
A set of basic electronic components complete with contact plate, connecting cables and board compatible with Arduino UNO R3. It is ideal for beginner electronics who also know Arduino. Uctronics KB0002
No product available!
A set of basic electronic components complete with contact plate, connecting cables and Arduino UNO R3. It is ideal for beginner electronics who also know Arduino. ArduCAM KB0001
No product available!
Orange filament 1.75 mm 0.85 kg Easy PLA by Fiberlogy
No product available!
No product available!
No product available!
12 pin GPIO ribbon cable (200mm) for Odroid XU4 and Odroid XU4Q
No product available!
7 pin GPIO ribbon cable (20 cm) for Odroid C4
No product available!
No product available!
3-wire cable with JST-ZH plug, 30 cm, 3x1 JST, 1.5 mm pitch
No product available!
A set for building a four-wheel, remote-controlled vehicle. Equipped with a programmable Arduino Uno R3 controller and set of sensors. modARD_02
No product available!
No product available!
No product available!
MICROPROCESSOR FREQUENCY METER 100MHZ - PRINTED PLATE