- Out-of-Stock
AVT527 DK
ID: 190196
AMERICAN DIGITAL OSCILLOSCOPE
AMERICAN DIGITAL OSCILLOSCOPE
Producer: AVT
There is no need to convince any electronics about the benefits of having an oscilloscope. Kit AVT527 is a solution to the problem of the lack of funds for the purchase of factory equipment.
The oscilloscope is housed on a 115x70 mm printed circuit board. Presentation of measurement results and all settings are made from a PC connected to the input circuits. The device consists essentially of two essential elements: hardware and software. The first one is used to convert the tested waveform to digital data. Sent to a computer, they are properly processed and presented on the screen. In addition, the electronic system must synchronize the start of the next ones to be sampled at the same point of the periodic test. Thanks to this the chart does not move and is readable. The hardware part of the device is also responsible for proper communication with the computer.
The system is uncomplicated in assembly and easy to start.
The device is especially recommended for the studio of every electronics dealing in analogue and digital technology
Selected parameters of the oscilloscope:
- number of channels - 1
- bandwidth - about 500 kHz
- time base - 12,5 us / div - 500 ms / div
- sensitivity - 10 mV / div - 400 mV / div
- sampling rate - 1Meater / s (8 bit resolution)
- synchronization with rising or falling edge (possibility of setting the trigger level)
- display of settings
- Fourier analysis
- connection with a computer - serial port
- work under Windows 98 and XP
- power supply - 5 V
- software
- Detailed description in
Download
190196
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
Vector network analyzer with two ports. It can perform measurements for frequencies from 50 kHz to 3 GHz. Equipped with an LCD display, it can be connected to a computer via USB. NanoV2 3.2"
Retired
No product available!
SDR (Software Defined Radio) receiver that allows you to receive signals in the frequency range from 10 kHz to 1 GHz. It is ideal for both monitoring low frequencies and receiving signals on higher bands
Retired
No product available!
Thermal imaging camera module with an MLX90640 infrared sensor and a 2.8" TFT LCD display. It offers an accuracy of 2°C and a viewing angle of 55°x35°.
Retired
No product available!
Antenna dedicated to communication in LoRa networks in the 868 MHz frequency band. Equipped with an RP-SMA connector. SparkFun WRL-18083
Retired
No product available!
Visible spectrum emitter module that combines 9 discrete LEDs covering visible light wavelengths from 455 to 720 nm. It uses Qwiic connectors and I2C communication as well as a USB type C socket to power the module. SparkFun SPX-21316
Retired
No product available!
WM8960 stereo codec module with driver for 1W class D speakers and headphones. It uses the I2S interface and the I2C bus to configure the system. SparkFun BOB-21250
Retired
No product available!
MP3 player module controlled by I2C interface or switching inputs. It is based on a 1.4 W audio amplifier. The board has a 3.5 mm audio output and a connector for connecting a loudspeaker. Files are played from a microSD card. SparkFun DEV-19030
Retired
No product available!
A set with an adapter dedicated to the FLIR Lepton thermal imaging camera and the Lepton FS camera. It has been pre-configured to operate as a plug-and-play UVC 1.0 USB camera, it can also communicate via UART and I2C interface. SparkFun DEV-20813
Retired
No product available!
Motion detection module featuring Panasonic\'s EKM series PIR sensor. The EKM series is optimised for detecting small movements and is ideal for detecting movement in a small area around the sensor. It offers digital output in 32 zones with a detection distance of 5 m and a detection area of 90° x 90°. SparkFun SEN-22000
Retired
No product available!
Antenna dedicated to communication in LoRa networks in the 868 MHz frequency band. Equipped with an RP-SMA connector. SparkFun WRL-18082
Retired
No product available!
Sensor module for electromyography (EMG). Allows muscle activity to be studied and used to control devices. SparkFun DEV-21265
Retired
No product available!
Portable soldering iron with a power of 65 W. It has an adjustable operating temperature in the range of 50 ° C to 400 ° C. It can be powered via a DC or USB type C connector. The set includes a soldering iron and a BC2 tip. MiniWare TS101 (BC2) Blue
Retired
No product available!
Flexible 25 cm microSD to SD adapter. Supports all card capacities and types including: 16GB, 32GB, 64GB, 128GB Micro SD/SDHC
Retired
No product available!
DAC converter with built-in headphone amplifier. It is powered by DC 5V/1A and can work with various power sources, ensuring operational stability and excellent sound quality. DAC-Q3 Pro
Retired
No product available!
The digital meter with smart testing function is an advanced measuring device that offers a wide range of functions and capabilities. It is compact and portable and complies with safety standards for accurate and reliable measurement results.
Retired
No product available!
Expansion module designed to work with a portable computer built into the Raspberry Pi 400 keyboard. The board has a 40-pin connector in a vertical position. SB Components 21239
Retired
No product available!
AMERICAN DIGITAL OSCILLOSCOPE