- Out-of-Stock
SimpleFOC brushless motor driver module dedicated to Arduino boards. It is based on the L6234 chip and allows you to control the movement of drives with a supply voltage from 12 to 24 V and current consumption up to 5 A. It can communicate via the SPI, I2C, ABI or analog interface. Full documentation is available on the product page.
Manufacturer
Responsible person
Arduino Uno Rev3 is a popular board with Atmel ATmega328 microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface. Arduino A000066
A set with ATmega2560 microcontroller (256 kB Flash, 8 kB RAM, 4 kB EEPROM) clocked at 16 MHz. The user has, among others: 54 I / O lines, 14 PWM channels, 16 analog inputs. Arduino A000067
STM32 Nucleo development board for STM32 F4 series - with STM32F401RE MCU, 512KB flash memory, STM, RoHS
No product available!
No product available!
No product available!
ZigBee module with an output power of 1 mW (+0 dBm) and a data transmission speed of up to 250 kb / s. Range up to 100 m. The module has 6 ADC lines (10-bit) and 8 GPIO lines. Requires an external antenna for the U.FL connector. SparkFun WRL-08666
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
RN41XV is a small form factor, low power Bluetooth radio module offering plug-in compatibility for the widely used 2 x 10 (2mm) socket typically used for 802.15.4 radio modules. WRL-11600
No product available!
The controller allows you to easily control the work of any device with the SPI interface via the USB port. All you need is a FTDI USB driver . TOL-09235
No product available!
Battery: Li-Po; 3.7V; 2000mAh; Outputs: wires with 2-pin JST-PH connector; 5.8 mm x 54 x 60 mm. PRT-08483
No product available!
No product available!
A single cell of a lithium-polymer battery, Sparkfun
No product available!
No product available!
Battery: Li-Po; 3.7V; 400mAh; Outputs: wires with 2-pin JST-PH connector; 5 x 25 x 35mm. PRT-10718
No product available!
No product available!
SimpleFOC brushless motor driver module dedicated to Arduino boards. SimpleFOC Shield v2.0.4