- Out-of-Stock
Very small and super-light lithium-polymer battery. Thanks to the use of the new Li-Pol chemistry, a very good ratio of the battery capacity to its mass was obtained. The battery has leads in the form of two wires terminated with a JST-PH connector. The battery has built-in protection against overvoltages, too high power consumption and against too low discharge.
Attention!
Li-Po batteries require a special charging method and the battery should be charged with chargers designed for lithium-polymer batteries.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Banana Pi camera module for Banana Pi M3, includes CMOS sensor module: OV5640 (5M Pixel)
No product available!
Printed circuit board and programmed AA / AAA cell capacity tester. AVT3169 A +
No product available!
AVT kit for self-assembly of tester capacity AA / AAA cells. AVT3169 B
No product available!
Assembled cell capacitor AA / AAA. AVT3169 B
No product available!
Printed circuit board for water level indicator. AVT1949 A
No product available!
AVT kit for self-assembly of the water level indicator. AVT1949 B
No product available!
No product available!
AVT kit for self-assembly of 230V AC delay switch. AVT1950 B
No product available!
No product available!
A circuit board for an android driver with FT311D. AVT5575 A
No product available!
AVT kit for self-assembly of an android driver with FT311D. AVT5575 B
No product available!
Assembled android driver with FT311D. AVT5575 C
No product available!
PCB and programmed circuit for the DDS generator for the 1Hz ... 40MHz range with the sweep. AVT5580 A +
No product available!
Printed circuit board for the construction of LED Easter eggs. AVT3160 A
No product available!
AVT kit for self-assembly of LED Easter eggs. AVT3160 B
No product available!
No product available!
Battery: Li-Po; 3.7V; 2000mAh; Outputs: wires with 2-pin JST-PH connector; 5.8 mm x 54 x 60 mm. PRT-08483