- Out-of-Stock
AVT1528 A
ID: 189999
INTERNET INTERFACE WITH ENC28J60 - PRINTED PLATE
INTERNET INTERFACE WITH ENC28J60 - PRINTED PLATE
Producer: AVT
It has been known for some time that microcontrollers can be connected via the LAN to the Internet. You need a microcontroller with a software TCP / IP protocol and an Ethernet interface. Integrated interfaces of this type were designed for network cards and therefore they were equipped with bus controllers, eg ISA and Plug & Play mechanisms. Extensive microcontrollers began to be equipped with mechanisms known from network cards. Their representative is the EN28J60 layout used in the project.
The device is especially recommended to the constructors of microprocessor systems cooperating with the Internet
Selected parameters:
- built-in high-speed SPI interface
- processor clocked at 25MHz
- ready-made program libraries
- power supply - 3.3Vdc
- printed circuit board and documentation included
A version with a set of independent components is available
- A detailed description in
Download
189999
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
No product available!
MT SPEC01 / 2015 RASPBERRY, ISSN 0462-9760
Delivery date unknown
No product available!
Dustyn Roberts
Delivery date unknown
No product available!
Atmel SMART SAM V71 Xplained Ultra development kit with ATSAMV71Q21 microcontroller with ARM Cortex-M7 core. ATSAMV71-XULT
Retired
No product available!
No product available!
No product available!
The module with the 74LVC245AD system allows connecting systems with different supply voltages. Bi-directional operation mode allows you to change the output to the input using a jumper or DIR input, without the need to disconnect the system. MOD-12.Z
Retired
No product available!
MOD-13.Z is a module that allows you to safely and conveniently attach a microSD card to a project with an SPI interface. It has a built-in 74HC125 buffer. MOD-13
Retired
No product available!
The SOIC adapter is used for testing circuits in SMD enclosures. The place for the stabilizer enables the selection of the supply voltage, as well as the supply of additional modules. The module is equipped with a filtering capacitor and space for a polymer fuse. MOD-14.Z
Retired
No product available!
MOD-16.Z replaces the two-button regulation (more - less) with the rotary switch whose state at the given output depends on the direction of rotation. The module has a button in the encoder and a built-in Attiny13 microcontroller.
Retired
No product available!
No product available!
No product available!
The miniature digital potentiometer allows you to replace the analog potentiometer and control the resistance value using two buttons. The module contains inputs of the UP / DOWN buttons (for increasing and decreasing the resistance) and outputs in accordance with the analog potentiometer A, W, B (description on the circuit board). MOD-19.Z
Retired
No product available!
Xmega eXploreGO module with ATXmega128A4U microcontroller (version without MP3). The module is equipped with in DataFlash memory, microSD card connector. MOD-20 / AZ
Retired
No product available!
MOD-21.Z - push button module with bistable operation. The sensor operates based on the AT42QT1012 system.
Retired
No product available!
The Raspberry Pi GPIO connector adapter allows you to output signals from Raspberry Pi to the contact plate. Two LEDs indicate +3.3V and +5V power supply
Retired
No product available!
INTERNET INTERFACE WITH ENC28J60 - PRINTED PLATE