- Out-of-Stock
FREQUENCY CIRCULATOR - PRINTED PLATES AND PROGRAMMED SYSTEM
Most of the constructors-radioelectronics constructing various radio devices measure the frequencies occurring in them. Such measurement, however, is burdened with an error resulting from the lack of calibration of the meter-frequency meter. Virtually all of the frequency meters presented in the literature operate on the basis of a reference generator designed on linearized gates and contain accidentally selected (without paying attention to its stability) quartz resonator. The error of such a device can even amount to +/- 3kHz at 10MHz. This can have a significant impact on the readings, making it impossible to even take some measurements.
The frequency calibrator we propose uses a GPS receiver as the source of reference signals. The stability of the obtained pattern is at the level of 200ns, which translates into a 2kHz error for 10MHz.
The device is particularly recommended in amateur and amateur radio studios
Selected parameters:
Download
Manufacturer
Responsible person
No product available!
No product available!
ARM7TDMI, 128kB Flash (ISP), 16kB RAM, 2xADC, DAC, 2xUART, 2xI2C, SPI, LQFP64, RoHS
No product available!
No product available!
The RS-485 / RS-422 transceiver from Maxim Integrates in the SO8 housing, allows the transmission of a signal with a throughput of up to 2.5Mbit / s, it has the ability to support up to 32 devices on a shared bus
No product available!
No product available!
No product available!
No product available!
8-bit ST7 MCU, 8kB Flash, 384B RAM, Lite Timer with Watchdog, Autoreload Timer with 32-MHz input clock, SPI, 10-bit ADC with Op-Amp, DIP20, RoHS
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
FREQUENCY CIRCULATOR - PRINTED PLATES AND PROGRAMMED SYSTEM