- Out-of-Stock
zł2,051.59
zł983.72
New products
New products New products
zł124.67
Delivery date unknown
Available
AVT5083 B
ID: 190483
MICROPROCESSOR LABORATORY POWER SUPPLY - KIT FOR INDEPENDENT INSTALLATION
MICROPROCESSOR LABORATORY POWER SUPPLY - KIT FOR INDEPENDENT INSTALLATION
Producer: AVT
Microprocessor laboratory power supply with a large range of voltage regulation and current limitation.
The value of the output voltage can be set in the range from 0.0V to 25V in 0.1V increments.
The maximum load current depends on the cooling conditions of the power transistor. In the model system it is 1A, with the possibility of limiting to 10mA with a jump of 70 mA. When the short circuit is detected, the power supply turns off, the display goes out and the red LED lights up. This condition lasts until the fault is removed. The set value of voltage or current limit is displayed on a three-digit seven-segment display.
Recommendations : for all electronic engineers who have their own studio or laboratory.
The set includes a printed circuit board, a set of elements and documentation.
Detailed description EP 10/02
Download
190483
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
THERMOSTAT REMOTE CONTROLLED BY PHONE (DTMF) - PLATEBOARD AND PROGRAMMED LAYOUT
Retired
No product available!
Flex Cable for Raspberry Pi Camera - 100mm / 4". Adafruit 1646
Retired
No product available!
RoboClaw 2x60AHV Motor Controller (V7C) is a two-channel DC motor driver, operating voltage: 10,5 to 60V, maximum continuous current: 60A, the ability to easily implement feedback loops with PID controller, security systems. Pololu 3583
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
The P-NUCLEO-IOM01M1 is an STM32 Nucleo pack composed of the STEVAL-IOM001V1 and the NUCLEO-F446RE board. The STEVAL-IOM001V1 is a single IO-Link master PHY layer (L6360) while the NUCLEO- F446RE runs an IO-Link stack rev 1.1
Retired
No product available!
No product available!
No product available!
No product available!
Anti-static brush, brush for cleaning printed circuit boards, elements after the soldering process
Retired
No product available!
Probe for measuring direct and alternating current with a current of up to 30 A. Works in the band up to 100 MHz, it can be connected to the oscilloscope through the UPI connector. It does not require an external power supply. Micsig CP1003
Retired
No product available!
No product available!
Rechargeable NiMH Battery Pack: 6.0 V, 200 mAh, 5x1 1/3-AAA Cells, JR Connector
Retired
No product available!
No product available!
MICROPROCESSOR LABORATORY POWER SUPPLY - KIT FOR INDEPENDENT INSTALLATION