- Out-of-Stock

Listening to music through headphones can be a source of many great aesthetic experiences, provided, however, that the amplifier is of sufficient quality. Therefore, we propose to make a headphone amplifier characterized by very good parameters despite the uncomplicated construction. The two-channel power amplifier bases its construction on the TDA7233 amplifier. For the correct operation, a minimum number of elements is required, which makes the project very simple. To the stereo minijack output connector we connect magnetodynamic headphones with an impedance greater than 2 ohms. The best results are achieved with headphones with impedance of 32 ohms / channel.
Recommendations: the device is especially recommended for enthusiasts of good sound, music lovers and musicians
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
No product available!
Orangutan SVP-324 Robot Controller (partial kit)
No product available!
The printed circuit board of the PIC16F84 development kit
No product available!
No product available!
Kit for building an intelligent JetBot robot based on Jetson Nano. It consists of Jetson Nano with 2GB RAM, expansion module, WiFi card, camera, motors, housing and a set of mounting screws. JetBot AI Kit (USB WiFi) 2GB
No product available!
3-color e-Paper display with a diagonal of 7.5 "and a resolution of 640x384 px. SPI interface. No PCB. Waveshare 7.5inch e-Paper (C)
No product available!
No product available!
No product available!
Side panel with sensors for Totem Mini Lab and Totem Micro Lab sets. The board has a microphone, OLED display, DH11 humidity sensor, NTC thermistor, buzzer and a DC motor control module. Totem TE-SP02-B
No product available!
No product available!
Camera for Odroid C1 / C1 + / C2 / C0 / XU4 computers with 720p quality with USB 2.0 interface. It runs under the control of Linux and Android 4.2.2 and above
No product available!
ROSA3D filament made of high-quality PET-G granules with a small addition of carbon fibers. 0.5 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PET-G CarbonLook
No product available!
No product available!
No product available!
ROSA3D filament made of high-quality ASA polymer. 0.7 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D ASA Silver
No product available!
No product available!
HIGH-QUALITY HEADPHONE AMPLIFIER - PRINTED PLATE