- Out-of-Stock
CEILING LIGHTING CONTROL - PRINTED PLUG AND PROGRAMMED SYSTEM
The ceiling light controller can be used as an element of the light architecture in the home. Because the aspect of energy saving is important, the light source is typical LED elements. In practice, you can use both LED strips and LED bulbs for 230V voltage.
The device is especially recommended as an element of modern home furnishings
Selected parameters:
Download
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
No product available!
No product available!
Portable Smart oscilloscope with 8-inch LCD display and touch screen. It has two measurement channels and is characterized by good measurement parameters: 150 MHz band, sampling rate 1 GSa/s and memory buffer 28 Mpts. Micsig STO1152 Plus
No product available!
No product available!
No product available!
No product available!
Wireless temperature sensor with high accuracy with built-in event memory (recorder) with transducer Si7053
No product available!
No product available!
MYIR MYC-SAMA5D36 is a single board computer in the form of a card with SO-DIMM 200-pin connector. It has been equipped with the SAMA5D36 processor from Atmel, based on Cortex-A5 cores. It can work with a maximum frequency of 536 MHz. It has 512 MB DDR2 SDRAM, 256 MB NAND FLASH memory. GPIO ports, interfaces have been derived on the SO-DIMM 200-pin connector
No product available!
No product available!
No product available!
GSM/GPRS + GPS module based on the RDA8955 chip. It integrates protocol stacks such as GSM/GPRS and supports the basic functions of voice calls, SMS and GPS data transmission. DFRobot TEL0134
No product available!
Raspberry Pi 2 and Pi 1 model B+ Enclosure - Clear
No product available!
No product available!
No product available!
No product available!
CEILING LIGHTING CONTROL - PRINTED PLUG AND PROGRAMMED SYSTEM