.png)
- Out-of-Stock
AVT548 A
ID: 193180
QUICK LOGIC FOR LV SYSTEMS - PRINTED PLATE
QUICK LOGIC FOR LV SYSTEMS - PRINTED PLATE
Producer: AVT
Low-voltage digital circuits (LV) become everyday in microprocessor and digital technology. Their use requires appropriate tools to test proper operation. Kit AVT548 is a specialized probe of logic states. Its adjustment (determination of logic levels) to the system under test consists in touching the tip to the supply voltage and pressing the button. This method of operation allows you to use the device in systems where there are several zones of supply voltages. The information is read by four LED diodes - their indications indicate high and low status, rectangular waveform as well as positive and negative pins. Invalid states are also signaled.
The device is especially recommended on the website and all electronics technicians involved in digital technology
Selected sampler parameters:
- operating modes: CMOS LV, TTL
- minimum pulse width - <10 ns
- maximum frequency of a square wave (50% fill) - approx. 100 MHz
- indications - LED diodes and LCD display
- built-in constant voltage voltmeter (0-5 V, resolution 0.1 V)
- power supply - 5 V (TTL), 1.6-4.4 V (CMOS LV)
- in the set there is a printed circuit board (without a pre-programmed circuit) and documentation
- Detailed description in
193180
Manufacturer
- AVT SPV Sp. z o.o.
- Leszczynowa 11
- 03-197 Warszawa
- Poland
- [email protected]
Responsible person
- AVT SPV Sp. z o.o.
- Leszczynowa 11
- 03-197 Warszawa
- Poland
- [email protected]
Other products in the same category (16)
Flora NeoPixel 30 RGB LED Strip in Reel - White Backing, 5 meters. Adafruit 1376
Retired
No product available!
With the Pmod Adapter for myRIO, you can now connect your myRIO to the expansive selection of Pmods offered by Digilent. 6002-410-013
Retired
No product available!
KAmodEPAPER is a module with a clear and energy-saving EPD (e-Paper) display of the GDE035A3 series. Thanks to the derived control signals and integrated in the inverter module, the display control is simple and no additional power lines are required
Retired
No product available!
Provides a 300 tie breadboard and 50 tie bus bar on an expansion card compatible with the NI myRIO Expansion Port (MXP). 210-283
Retired
No product available!
The GP2Y0A60SZ distance sensor from Sharp offers a wide detection range of 4″ to 60″ (10 cm to 150 cm) and a high update rate of 60 Hz. The distance is indicated by an analog voltage, so only a single analog input is required to interface with the module.
Retired
No product available!
The GP2Y0A60SZ offers a wide detection range of 4″ to 60″ (10cm to 150cm) and a high update rate of 60Hz. The distance is indicated by analog voltage - only a single analog input is required to interface with the module. Pololu 2476
Retired
No product available!
Shield for STM32 Nucleo with WiFi module b / g / n SPWF01SA. The module\'s firmware allows you to work as a client and UDP / TCP server, a web server, supports TCP / IP, TLS / SSL protocols. There are 16 GPIO lines available
Retired
No product available!
Shield X-NUCLEO-IHM09M1 from ST allows you to connect BLDC motor driver modules for STM32 Nucleo tiles
Retired
No product available!
STM32 Nucleo-144 development board with STM32F746ZGT6 MCU, supports Arduino, ST Zio and Morpho
Retired
No product available!
STM32 Nucleo-144 development board with STM32F429ZIT6 MCU, supports Arduino, ST Zio and Morpho
Retired
No product available!
The ST25TA02KB-P is a dynamic NFC/RFID tag IC with a digital General Purpose Output (GPO), embedding a 2 Kbit EEPROM that supports NDEF tag applications for NFC Forum Type 4
Retired
No product available!
Gearmotor is a powerful 12V brushed DC motor with a 50:1 metal gearbox and an integrated quadrature encoder
Retired
No product available!
T-Cobbler adapter enabling connection of GPIO Raspberry Pi A +, B +, Pi 2 and Pi 3 lines to the contact plate (2.54 mm). Adapter assembled, including connecting tape
Retired
No product available!
Particle Photon is an IoT module with an ARM microcontroller (Cortex-M3) and a WiFi module. The module has a 2.54 mm goldpin connector. WRL-13774
Retired
No product available!
SBC computer with SoC Allwinner H8 (8-core Cortex-A7 2 GHz, PowerVR SGX544MP) equipped with: in 2 GB RAM memory, 8 GB eMMC memory, WiFi a / b / g / n, Bluetooth, SATA 2.0 interface
Retired
No product available!
No product available!
QUICK LOGIC FOR LV SYSTEMS - PRINTED PLATE