- Out-of-Stock
AVT1579 A
ID: 193680
AMPLIFIER 2x15W WITH STK4392 - PRINTED PLATE
AMPLIFIER 2x15W WITH STK4392 - PRINTED PLATE
Producer: AVT
The STK4392 system used in the kit is produced by Sanyo. It is a complete solution of a stereo power amplifier. The ease of its application makes it possible to build a small number of elements of an audio amplifier with quite good parameters. Its output power is sufficient for most interiors of modern apartments.
The device is especially recommended for audiophiles and music lovers
Selected parameters:
- 2x15W power
- 8 ohm load impedance
- input impedance 110kom
- distortion <1%
- built-in short-circuit and overheating protection
- power supply - up to 56Vdc
- printed circuit board and documentation included
- A detailed description in EP 8/10
Download
193680
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
Evaluation kit with RISC-V Dual Core 64bit chip clocked at 400MHz. Equipped with a USB-UART converter, OV2640 camera, LCD display. The set is enclosed in a housing. Designed for AI applications in IoT. Seeed Studio 110991191
Retired
No product available!
No product available!
A hand-held thermal imaging camera with a 2.4" LCD screen. It measures the temperature in the range from -20 to 300°C. HTI HT-02D
Retired
No product available!
Camera module with Sony Starvis IMX462 sensor that works with Raspberry Pi minicomputers. It has a 2 MP sensor and an 80° viewing angle lens, and is equipped with a movable IR-CUT filter. ArduCAM B0423
Retired
No product available!
No product available!
No product available!
No product available!
Module designed for connecting more than one camera to a single CSI camera port on RPi board. One adapter board can connect 4 cameras and user can stack up max. 4 adapter boards that means up to 16 cameras on a single RPi board. ArduCAM B0069
Retired
No product available!
No product available!
Kit for building a giraffe robot controlled by a wire with a switch. Totem TKR-GRF
Retired
No product available!
Battery: Li-Po; 3.7V; 2000mAh; Outputs: wires with 2-pin JST-PH connector; 5.8 mm x 54 x 60 mm. PRT-08483
Retired
No product available!
No product available!
Development kit containing the M24LR04E-R EEPROM chip. It consists of two ready-to-use boards that can communicate with each other via the I2C or RFID bus.
Retired
No product available!
No product available!
Marek Domański
Delivery date unknown
No product available!
No product available!
AMPLIFIER 2x15W WITH STK4392 - PRINTED PLATE