- Out-of-Stock
A computer with a 64-bit Intel Celeron J4105 quad-core processor (x86, 2.5 GHz) and 2 DDR4 RAM memory slots. Additional equipment includes: Gigabit Ethernet, HDMI 2.0 port and Display Port 1.2 4K / 60Hz, and four USB ports, 20 GPIO, PCI-e slot and two SATA3 connectors. ODROID H2
Odroid H2 for minicomputer with Intel Celeron J4105 quad-core processor (2.5 GHz, 64-bit), has 2 slots for DDR4 RAM modules (a list of compatible files can be found at: https://wiki.odroid.com/odroid-h2/hardware/ram). In addition, it is equipped with: Gigabit Ethernet, HDMI 2.0 port and Display Port 1.2 4K / 60Hz, four USB ports, 20 GPIO, PCI-e slot and two SATA3 connectors.
Odroid H2 works with Ubuntu 19.04 and Ubuntu 18.04 servers. Revision B has: a pull-up resistor for the CLK-REQ signal to support PCIe-SATA cards, an improved 12 V power supply section for HDDs connected to the SATA interface, a screw for installing NVMe memory (M.2), the latest version being configured BIOS 1.05.

| A | CPU (Intel Celeron J4105 Processor) | K | 1 x DisplayPort 1.2 |
| B | 2 x DDR4 SO-DIMM slots (Dual channel memory support) | L | 2 x RJ45 Ethernet Ports (10/100/1000) |
| C | 1 x M.2 PCI Express Module Socket (NGFF-2280) | M | 5 x LED Indicators system |
| D | 1 x eMMC (Embedded Multimedia-Card) Socket | N | 1 x Peripheral Expansion Header (20-pin) |
| E | 2 x SATA Power Connectors | O | 1 x Power Switch |
| F | 2 x SATA3 6.0 Gb / s Data Connectors | P | 1 x Reset Switch |
| G | 1 x DC Power Jack | Q | 1 x Backup Battery Connector (2-pin) |
| H | 2 x USB 3.0 | R | 1 x Active Cooling Fan Connector (4-pin) |
| I | 2 x USB 2.0 | S | 1 x Audio out 1 x Audio in 1 x SPDIF out |
| J | 1 x HDMI 2.0 |
Manufacturer
Responsible person
This CR2032 allows the system to keep its onboard clock-time ticking when a battery or power supply is disconnected. This battery can keep the RTC running up to 3 years without external power supply. RTC Backup Battery
Best low-cost environmental sensing solution with BME280 and Si1132 on one board. The combination of the BME280 sensor and the Si1132 sensor enables measuring temperature, barometric pressure and humidity, UV Index and ambient light at once
The oCam supports plug-and-play by UVC compliant adapting the standard M12 lens with focal length of 6mm
No product available!
USB-UART converter for Odroid minicomputers. It is based on the CP2102N chip and is equipped with a USB type C connector
No product available!
A small Li-Pol battery with a nominal voltage of 3.7 V and a capacity of 1350 mAh. Leaded wires, dimensions: 5 x 37 x 59 mm. Akyga LP503759
No product available!
Thermistor for THT assembly with a resistance of 10k, a temperature coefficient of 3380K and accuracy of 1%. The sensor body is Ø2.5x4mm
No product available!
KAmduino UNO is a development board with functionality and dimensions typical for Arduino UNO. Thanks to the built-in ATmega328P microcontroller and the FT231X chipset, the board can be programmed via a USB interface using the Arduino environment. KAmduino UNO
No product available!
K64 microcontroller with ARM® Cortex®-M4 core, 1MB Flash memory, 256kB RAM, 120MHz, SPI, I2C, I2S, UART, CAN, USB OTG, ADC, DAC, RTC, DMA, LQFP100
No product available!
SmartLED Shield driver (V4) for SmartMatrix series displays, for use with Teensy 3.2, Teensy 3.5 and Teensy 3.6. It is also possible to connect LED Dotstar or APA102 displays. Adafruit 1902
No product available!
Add motion, direction and orientation sensing to your wearable FLORA project with this high precision 9-DOF sensors: 3-axis accelerometer, 3-axis magnetometer and 3-axis gyroscope. Adafruit 2020
No product available!
Ambient Light Sensor, SI1145, connects to the I2C bus pads. Adafruit 1981
No product available!
Extension for Raspberry Pi; communication module with RS-485 interface (DEV-13000). Module with the possibility of mounting the DB-9 socket, the socket should be purchased separately
No product available!
FreeSoC2 board has two processors on-board: a CY8C5868LTI-LP039 and a CY8C5888AXI-LP096. The former serves as a debugger/programmer for the latter, which is the target upon which your application code will be installed. Both parts contain a Cortex-M3 processor core, 256kB of flash memory, 64kB of SRAM, and 2kB of EEPROM. DEV-13229
No product available!
32-bit microcontroller with ARM Cortex-M4 core, XMC4200 family, 256kB Flash, VQFN-48, Infineon
No product available!
No product available!
Translator of TI voltage levels, bidirectional (no signal required to control the flow direction), 8-Bit, especially recommended for use in Push-Pull and Open-Drain systems. The system has a TSSOP20 housing
No product available!
Aluminum extensometer beam, allowing measurement of weight up to 1 kilogram. It has four wires. It is used in kitchen scales and portable scales.
No product available!
Aluminum extensometer beam, allowing weight measurement up to 3 kilograms. It has four wires. It is used in kitchen scales and portable scales.
No product available!
Aluminum extensometer beam, allowing mass measurement up to 5 kilograms. It has four wires. It is used in kitchen scales and portable scales.
No product available!
A two-wire, serial extender for I2C bus, SMBus and HDMI DDC, working at 2.7 V - 5.5 V. The system has a TSSOP8 housing. PCA9507DP
No product available!
A computer with a 64-bit Intel Celeron J4105 quad-core processor (x86, 2.5 GHz) and 2 DDR4 RAM memory slots. Additional equipment includes: Gigabit Ethernet, HDMI 2.0 port and Display Port 1.2 4K / 60Hz, and four USB ports, 20 GPIO, PCI-e slot and two SATA3 connectors. ODROID H2