- Out-of-Stock
Flora UV Index Sensor - Si1145 Light Sensor
ID: 558623
Ambient Light Sensor, SI1145, connects to the I2C bus pads. Adafruit 1981
Description
Your wearable can now keep you from getting sunburnt, with the Flora digital UV index sensor. We took our popular SI1145 UV index sensor and cut out everything you don't need for using with a Flora. It's small, round, and connects to the I2C bus pads. Flora can even use our library code to get calibrated light level and UV index data from the sensor.
Please note: this sensor can be used by Flora but is too complex for Gemma!
To use: connect the 3V, SDA and SCL, and GND pads of the sensor to your Flora 3V/SDA/SCL/GND pads, in that order. Then load up our Arduino library and example code from our tutorial to your Flora.
Features
- IR Sensor Spectrum: Wavelength: 550nm-1000nm (centered on 800)
- Visible Light Sensor Spectrum: Wavelength: 400nm-800nm (centered on 530)
- Voltage Supply: Power with 3 VDC
- I2C address 0x60 (7-bit)
- Operating Temperature: -40°C ~ 85°C
558623
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
This is the second version of the Flora NeoPixels, which runs at at \'high speed\' 800KHz communication. Adafruit 1260
zł43.46
24h
Available quantity: 1
Available
The Flora budget starter kit contains everything you need to start an adventure with smart clothing. Included, among others motherboard, LED diodes, conductive cord, battery basket. Adafruit 1405
zł206.07
Delivery date unknown
No product available!
FLORA is Adafruit\'s fully-featured wearable electronics platform. It\'s a round, sewable, Arduino-compatible microcontroller designed to empower amazing wearables projects. Adafruit 659
Regular pricezł76.69zł66.26
Delivery date unknown
No product available!
Other products in the same category (16)
The device allows the presence of devices with BLE in networks with Ethernet protocol, extends the range of sensors iNode Care Sensor
Retired
No product available!
A wireless energy consumption monitor with built-in memory, thanks to the analysis of daily consumption, can help reduce the cost of electricity consumption
Retired
No product available!
A wireless energy consumption monitor with built-in memory, thanks to the analysis of daily consumption, can help reduce the cost of water consumption
Retired
No product available!
Flex Cable for Raspberry Pi Camera - 200mm / 8". Adafruit 1647
Retired
No product available!
MYIR MYC-C7Z010 is a single board module based on the MYC-C7Z010 chip. This system consists of a dual-core processor based on the Cortex-A9 core (667 MHz) and the Artix-7 FPGA chip. The board has 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board is equipped with numerous peripherals, the outputs of which have been led out on two 140-pin connectors.
Retired
No product available!
No product available!
AVT kit for self-assembling LEDs, contains a set of elements. AVT1844 B
Retired
No product available!
Assembled AVT set, Christmas, shining Christmas tree LED. AVT1844 C
Retired
No product available!
The sensor detects dangerous carbon monoxide and carbon monoxide, signals a gas leak and the presence of carbon monoxide in rooms. URZ0409
Retired
No product available!
Female-female 10-core connection cable, 15 cm long with connectors of 1.27 mm pitch. Adafruit 1675
Retired
No product available!
32GB microSDHC Memory Card with SD Adapter, class 4, Kingston
Delivery date unknown
No product available!
Development kit chipKIT DP32 equipped with PIC32MX250F128B microcontroller (40/50 Mhz, 128 kB Flash, 32 kB RAM), prototype area with solder pads, potentiometer, 4 LED diodes, 2 buttons and soldering pads for EEPROM memory and analog temperature sensor. Digilent 410-280P-KIT
Retired
No product available!
large 14x21 hole prototyping area on an expansion card compatible with the myRIO Expansion Port (MXP). 6002-210-008P
Retired
No product available!
Perfect for connecting devices using Wi-Fi, Ethernet and Power over Ethernet options, the Yun combines an ATmega32u4 microcontroller with a Linux based Linino WiFi System on Chip module. A000003
Retired
No product available!
LPCXpresso4337 starter board with a dual-core LCP4337 microcontroller (Cortex-M4F + Cortex-M0 +). The set is equipped with a built-in programmer, buttons, diode, SPI Flash quad flash and USB - UART konwetrer
Retired
No product available!
Starter board LPCXpresso18S37 with LPC18S37 microcontroller (Cortex-M3). The set is equipped with a built-in programmer, buttons, diode, SPI Flash quad flash and USB - UART konwetrer
Retired
No product available!
Ambient Light Sensor, SI1145, connects to the I2C bus pads. Adafruit 1981