- Out-of-Stock
Dual driver for DC motors. It allows you to control two drives with a voltage in the range from 6 to 16 V. The controller is based on the Toshiba VNH2SP30 chip, thanks to which a current of 13 A (30 A temporary) can be taken from each channel. The module allows you to connect a microcontroller or a computer with a serial port (an external RS-232 level converter is required) or a USB-UART adapter. The protocol used uses the function of automatic detection of baud rates up to 115.200 kbps and optional CRC error control. Two status LEDs provide visual feedback on the serial connection and any errors for easy debugging, while the demo mode allows you to easily verify correct operation. The controller uses a high-frequency PWM (ultrasonic) signal to eliminate the switching-induced motor hum.

Data sheet
Manufacturer
Responsible person
Pololu Low-Voltage Dual Serial Motor Controller
USB - UART converter based on the PL2303 chip. Compatible with voltages of 1.8 V, 2.5 V, 3.3 V and 5 V, it is equipped with a USB type A connector. Waveshare PL2303 USB UART Board (type A) V2
INTEL EDI2ARDUIN.AL.K Intel Edison Kit For Arduino, Atom, Wi-Fi/BT Compatible Module, Integrated Wi-Fi, 4GB Memory
No product available!
Orange Pi Plus 2 H3 Quad Core 1.6GHZ 2GB RAM 4K Open Source Development Board Mini PC
No product available!
Rainbow Case (Type B) for Raspberry Pi
No product available!
No product available!
Flora NeoPixel 30 RGB LED Strip in Reel - White Backing, 5 meters. Adafruit 1376
No product available!
With the Pmod Adapter for myRIO, you can now connect your myRIO to the expansive selection of Pmods offered by Digilent. 6002-410-013
No product available!
KAmodEPAPER is a module with a clear and energy-saving EPD (e-Paper) display of the GDE035A3 series. Thanks to the derived control signals and integrated in the inverter module, the display control is simple and no additional power lines are required
No product available!
Provides a 300 tie breadboard and 50 tie bus bar on an expansion card compatible with the NI myRIO Expansion Port (MXP). 210-283
No product available!
The GP2Y0A60SZ distance sensor from Sharp offers a wide detection range of 4″ to 60″ (10 cm to 150 cm) and a high update rate of 60 Hz. The distance is indicated by an analog voltage, so only a single analog input is required to interface with the module.
No product available!
The GP2Y0A60SZ offers a wide detection range of 4″ to 60″ (10cm to 150cm) and a high update rate of 60Hz. The distance is indicated by analog voltage - only a single analog input is required to interface with the module. Pololu 2476
No product available!
USB adapter for PC, allowing Bluetooth v4.0 communication with speeds up to 3Mb / s and range up to 20m
No product available!
Shield for STM32 Nucleo with WiFi module b / g / n SPWF01SA. The module\'s firmware allows you to work as a client and UDP / TCP server, a web server, supports TCP / IP, TLS / SSL protocols. There are 16 GPIO lines available
No product available!
Shield X-NUCLEO-IHM09M1 from ST allows you to connect BLDC motor driver modules for STM32 Nucleo tiles
No product available!
STM32 Nucleo-144 development board with STM32F746ZGT6 MCU, supports Arduino, ST Zio and Morpho
No product available!
STM32 Nucleo-144 development board with STM32F429ZIT6 MCU, supports Arduino, ST Zio and Morpho
No product available!
The ST25TA02KB-P is a dynamic NFC/RFID tag IC with a digital General Purpose Output (GPO), embedding a 2 Kbit EEPROM that supports NDEF tag applications for NFC Forum Type 4
No product available!
A double driver that allows you to drive two DC motors with a voltage from 6 to 16 V and a continuous current of 13 A per channel. It communicates via the serial interface. Pololu 1112