- Out-of-Stock
Rechargeable NiMH Battery Pack: 8.4 V, 900 mAh, 4+3 AAA Cells, JR Connector
This is a rechargeable 8.4 V NiMH battery pack with a capacity of 900 mAh. The pack consists of seven AAA cells in two rows and a 4" lead terminated by a “JR”-style connector.
![]() |
This battery pack comes with 4" leads terminated by a 3-pin JR-style female connector (only two of the pins are used). The connector is the same as what is found on the most servos and has a 0.1" spacing, so it fits nicely with 0.1" male headers and can plug directly into most RC receivers, servo extension cables, and servo switch harnesses, and custom cables made with JR male connectors or Futaba J male connectors. Note, however, that this style of connector is often referred to as “male” in the RC hobby industry, so please use the picture on the right to clear up any potential confusion.
Our rechargeable NiMH battery packs give you variety of options for powering your robot or electronics project. The battery packs use 1.2 V cells and are available in several capacities:
![]() |
| Cell Type | Capacity (mAh) |
|---|---|
| AA | 2200 |
| AAA | 900 |
| 2/3 AAA | 350 |
| 1/3 AAA | 200 |
The picture to the right shows the relative sizes of our NiMH battery packs. These packs are well-suited for powering small robots, and the smaller (1/3- or 2/3-AAA) battery packs make great power sources for miniature robots, such as those that might be based on our Baby Orangutan robot controller.
|
|
Battery pack color may differ from what is shown in the main product picture.
Note: The battery voltages listed in the product descriptions are based on the 1.2 V nominal voltage of the NiMH cells from which the packs are made. The actual voltage will depend on how charged the batteries are. A fully charged NiMH cell will deliver almost 1.5 V, so, for example, a “6V”, 5-cell pack can measure over 7 volts after being charged, and it can fall well below 5 volts when the pack is drained. You will need to charge these battery packs before you first use them. The iMAX-B6AC battery charger works well with these battery packs.
Data sheet
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Nettemp Pi Hat is a module that allows to connect eight trees of sensors with I2C/1-Wire interface and control of four relays outputs. Thanks to the extension board is possible to build in an easy way e.g. a multipunkt temperature controller.
No product available!
32GB microSDHC Memory Card with SD Adapter, class 10 A1, Kingston
No product available!
WiFi 802.11 b / g / n module with ESP8266 system, 5 leads are available with 2 mm pitch with the possibility of soldering of gold pins, power lines, reset line and UART interface have been led to the connector. 3.3V power supply
No product available!
WiFi 802.11 b / g / n module with ESP8266 system, 8 pins with 2.54 mm pitch are available with soldered gold pins, 3 GPIO lines, reset, power supply and UART interface on the connector. U.FL. Antenna Connector 3.3 V power supply
No product available!
nRF51 DK is a development board based on the nRF51422 system with Bluetooth Low Energy (BLE) and 2.4 GHz connectivity. The module has a connector compatible with Arduino shields, buttons and diodes available to the user.
No product available!
No product available!
No product available!
Featuring a quad-core Amlogic processor, advanced Mali GPU, and Gigabit Ethernet
No product available!
The case has openings for all outputs including the GPIO port making it a great fit for projects that are connected to external hardware.
No product available!
The case has openings for all outputs including the GPIO port making it a great fit for projects that are connected to external hardware.
No product available!
Super charged single board computer with an Octa-core processor and 2GB of RAM. Along side the elite processing unit, it features Gigabit Ethernet, 2 USB, SATA, WiFi, Bluetooth, and HDMI connection. It can run on a variety of operating systems including Android, Lubuntu, Ubuntu, Debian, and Raspbian
No product available!
Works with the ODROID-C2 / C0 / C1+. The HiFi Shield provides both stereo RCA connectors and a 3.5mm stereo jack (all gold-plated) to connect to external amplifiers and other audio equipment
No product available!
No product available!
This rev of the RS232 Shield provides with the option to choose between two pins from an Arduino (D0 to D7) as software serial ports to communicate with RS232 Shield. DEV-13029
No product available!
The HSPA / GSM modem card with the miniPCIe connector allows to obtain 14.4 Mbps "up" transmission speed and 5.76 Mb / s "down" transmission, working on four ranges. HUAWEI MU609
No product available!
No product available!
Rechargeable NiMH Battery Pack: 8.4 V, 900 mAh, 4+3 AAA Cells, JR Connector