- Out-of-Stock

This single-pole, double-throw (SPDT) switch can be used as a general-purpose micro switch or tactile bump sensor for your robot. The switch body dimension is 20.0 x 6.4 x 10.2 mm, and the 15.6mm lever arm has a semicircular bump at the tip that simulates a roller.
This single-pole, double-throw (SPDT) switch can be used as a general-purpose micro switch or tactile obstacle-detector for your robot. The switch body dimension is 20.0 x 6.4 x 10.2 mm (0.79" x 0.25" x 0.40"), and the 15.6mm (0.61") lever arm has a semicircular bump at the tip that simulates a roller. This three-pin switch can also be used as a two-pin single-pole, single-throw (SPST) switch that is open or closed by default, depending on which two pins are used.
![]() |
Dimensions (in mm) of snap-action switch with 15.6mm bump lever: 3-pin, SPDT, 5A. |
---|
For a more sophisticated tactile sensor, see our force-sensing resistors.
![]() |
Snap-Action Switch with 50mm Lever: 3-Pin, SPDT, 5A |
![]() |
Snap-Action Switch with 16.3mm Roller Lever: 3-Pin, SPDT, 5A |
![]() |
Snap-Action Switch with 16.7mm Lever: 3-Pin, SPDT, 5A |
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Banana Pi R2 is a mini-computer (router) equipped with a Quad-core ARM Cortex-A7 quad-core MediaTek MT7623N processor, 2 GB of RAM, WiFi module, Bluetooth 4.1 and connectors: HDMI, 5 x Ethernet, 2x USB 3.0. The set has a 40-pin GPIO connector, on which you can find UART, SPI, I2C and ID EEPROM interfaces.
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
MYS-6ULX-IND is a small single board computer (SBC - Single Board Computer) designed specifically for use in Industry 4.0. It has a built-in NXP MCIMX6G2CVM05A processor based on the Cortex A7 core, which can operate at a maximum frequency of 696 MHz
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
Spring dedicated to the heating table of 3D printers. It allows you to adjust the degree of tightening the knob, and thus enables the proper leveling of the working table
No product available!