- Out-of-Stock
PROTECTION OF LEADER BATTERY - PRINTED PLATE
Producer: AVT
The commonly used acid batteries, despite their unquestionable advantages, have one disadvantage: excessive discharge has a negative impact on their lifetime. The presented system allows to prevent this phenomenon by disconnecting the load when the voltage at the terminals of the cell falls below the set level. The device is intended for accumulators with a nominal voltage of 12V and 24V
The printed circuit board and documentation are included.
A detailed description in EP7 / 13 or ![]()
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
No product available!
No product available!
No product available!
Printed circuit board for the modular listening receiver for the 80m and 40m Dosia bands. Mixer with CW / SSB amplifiers. AVT3191 A
No product available!
No product available!
No product available!
No product available!
No product available!
LAMPSOLAR-LED CONTROLLER for photovoltaics POWERED - PHOTO PLATE AND PROGRAMMED LAYOUT
No product available!
No product available!
No product available!
No product available!
Male terminal block, angled, 6-pin. Pitch 3.5mm. Height 9.2mm. KF2EDGR
No product available!
HDMI to CSI-2 bridge module based on TC358840 chip. It has a 22-pin FPC connector with a pitch of 0.5 mm and an audio connector. The input signal is supplied through the HDMI connector. Auvidea 70511
No product available!
No product available!
No product available!
PROTECTION OF LEADER BATTERY - PRINTED PLATE