- Out-of-Stock
New products
New products New products
zł259.00
Delivery date unknown
Available
zł50.18
24h
Available
AVT3053 A
ID: 208500
RC5 RELAY CARD - PLATE
RC5 RELAY CARD - PLATE
Producer: AVT
Presented system is used for wireless control via RC5 remote control with any six devices connected to relays. The device allows you to calibrate the remote control buttons at the first start or at any time. All settings are stored in non-volatile EEPROM memory. At any time during the operation of the system, it is possible to block the possibility of controlling power outputs via the remote control. For safety reasons, the system was also equipped with an emergency switch for all relays, without the use of a remote control.
The printed circuit board and documentation are included.
Detailed description in EdW3 / 13 or 
208500
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
No product available!
Printed circuit board and programmed circuit for unipolar stepper motor driver. AVT1985 A +
Retired
No product available!
No product available!
No product available!
Pololu Dual VNH2 Motor Driver + Tamiya 72101 Gearmotor Sponge Tire
Retired
No product available!
NanoPi NEO is a miniature board with the all-in-one SoC Allwinner H3 chip (ARM Cortex-A7) with built-in Ethernet communication. Works with Ubuntu MATE, Debian, etc. It can be powered by the microUSB port. The board also contains a USB port, a serial port and a 36-pin GPIO connector
Retired
No product available!
Side panel with sensors for Totem Mini Lab and Totem Micro Lab sets. The board has a microphone, OLED display, DH11 humidity sensor, NTC thermistor, buzzer and a DC motor control module. Totem TE-SP02-B
Retired
No product available!
Maciej Szafarczyk, Dominika Śniegulska-Grądzka, Rafał Wypysiński
Delivery date unknown
No product available!
UART GPS Module, NEO-7M-C is a module containing the U-blox NEO-7M GPS receiver system. The tile also includes RTC backup battery, antenna connector (U.FL), voltage stabilizer and UART interface signal outputs. Waveshare UART GPS NEO-7M-C
Retired
No product available!
No product available!
No product available!
No product available!
7-segment LED display, 1 digit 13.20mm, green (575nm), 5mcd (10mA), common anode, red (630nm), 6mcd (10mA), common anode. Pb-free. LED1-AS-B-05211BMRMG
Retired
No product available!
800x480, 7 inch Multicolor Graphic LCD, with capacitive touch screen and stand-alone touch controller
Retired
No product available!
No product available!
No product available!
RC5 RELAY CARD - PLATE