- Out-of-Stock
AVT3059 A +
ID: 208520
DIGITAL PHASER CONTROLLER - PLATEBOARD AND PROGRAMMED LAYOUT
DIGITAL PHASER CONTROLLER - PLATEBOARD AND PROGRAMMED LAYOUT
Producer: AVT
The device is used to smoothly regulate the power of devices powered with 230 VAC. It can be used in situations when it is necessary to reduce the power of resistive loads, eg heaters, light bulbs, etc. The controller has been equipped with a readable LCD display, which displays the device's power in percentage, in the range from 0 to 100%. The adjustment takes place by means of two microswitches.
Recommendations: The device will be used in the workshop of every electronics and not only.
The set includes a printed circuit board, programmed layout and documentation.
Detailed description in EdW5 / 13 or 
Attention!!! There are tensions dangerous to life and health in the system. Minors can perform, run and calibrate the system only under the supervision of qualified adults - teachers.
208520
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
TEMPERATURE CONTROLLER - THERMOSTAT FOR EVERYONE - A KIT FOR INDEPENDENT INSTALLATION
Retired
No product available!
Black nylon filament with carbon fiber PA12 + CF5, 1.75 mm in diameter. 0.5 kg of filament is wound on the spool. Fiberlogy Nylon PA12 + CF5 Black
Retired
No product available!
High quality XF-ABS filament for 3D printer with 1.75 mm diameter. 1 kg of wire is wound on the spool.
Retired
No product available!
OLED display 128x64 pixels, 0.96 ", 3V power supply, SSD1306 controller, communication via I2C and SPI interfaces, PARALLEL WHITE display color, working temperature from -40 to +70, ext. CAP
Retired
No product available!
No product available!
No product available!
No product available!
The switch module has a relay with a control function via a WiFi network. It can be connected to a WiFi network or act as a stand-alone access point. Shelly 1 Open Source
Retired
No product available!
Low cost programmer for STM32 and STM8 microcontrollers fully compatible
with the ST-Link V2
Retired
No product available!
No product available!
Arducam-LF Rev.C+ Camera module + 3.2 inch LCD for arduino UNO MEGA2560 DUE. ArduCam B0052+B0011
Retired
No product available!
Minicomputer with a dual-core processor (up to 2.0 GHz) and 4 GB of LPDDR3 RAM memory, 16 GB of eMMC Flash memory. It has a two-band WiFi 2.4G and 5G module. Supports GPU and VPU acceleration. It has video interfaces in the form of HDMI, as well as USB 3.0, USB2.0, MicroSD, Ethernet port and 3.5mm audio socket. FriendlyElec NanoPC-T4
Retired
No product available!
No product available!
MYIR MYC-JA5D44 is a single-board computer in the form of a card with SO-DIMM 200-pin connector. The SAMA5D44 processor from Atmel, based on Cortex-A5 cores, has been equipped. It can work with a maximum frequency of 600 MHz. It has 512 MB of DDR2 SDRAM, 512 MB of NAND Flash memory. GPIO ports, interfaces have been derived on the SO-DIMM 200-pin connector.
Retired
No product available!
Miniature camera module with OV5647 5MP sensor dedicated to Raspberry Pi Zero and Compute Module. Equipped with a lens with a viewing angle of 120°, no IR filter. ArduCAM B006604N
Retired
No product available!
No product available!
DIGITAL PHASER CONTROLLER - PLATEBOARD AND PROGRAMMED LAYOUT