- Out-of-Stock

POWER SUPPLY OF CONTACT TILES, OR HOW POWERED EDW09 - PRINTED PLATE
Producer: AVT
Due to the emergence of the PKE course in the Electronics for All and Young Tech and the introduction of the EdW A09 set, a certain gap appeared among the power supplies offered by AVT. None of them is directly intended to supply contact plates (prototype) SD-12, which is why this project was created.
The printed circuit board and documentation are included
Detailed description in EdW9 / 13 or
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
No product available!
No product available!
No product available!
No product available!
Printed circuit board and programmed layout for the Arduino learning board. AVT5636 A +
No product available!
Module with E-Ink (e-Paper) display with a diagonal of 2.9"and a resolution of 296x128 px with WiFi communication. Adafruit 4800
No product available!
The housing for the Banner PI G1 Debugger made of transparent plastic. Housing for self-assembly
No product available!
No product available!
The official additional internet power board (PoE) for Raspberry Pi 3 B + and Raspberry Pi 4 B allows you to use the PoE interface to power Raspberry Pi via an Ethernet cable, eliminating the need for a separate power supply. RPI3-MODBP-POE
No product available!
No product available!
ROSA3D filament made of high quality PVB. 0.5 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PVB Navy Smooth
No product available!
No product available!
No product available!
Battery: Li-Po; 3.7V; 2000mAh; Outputs: wires with 2-pin JST-PH connector; 5.8 mm x 54 x 60 mm. PRT-08483
No product available!
Set with 2 DOF control platform for cameras designed for Raspberry Pi minicomputers. The platform is based on two digital servos that allow you to control the position of the camera in two dimensions. ArduCAM B0227
No product available!
No product available!
POWER SUPPLY OF CONTACT TILES, OR HOW POWERED EDW09 - PRINTED PLATE