- Out-of-Stock
PCF8591P (DIP16)
ID: 22793
8-bit A / D and D / A converter, DIP16, RoHS
PCF8591P
8-bit A / D and D / A converter, DIP16, RoHS
The PCF8591 is a single-chip, single-supply low power 8-bit CMOS data acquisition device with four analog inputs, one analog output and a serial I2C-bus interface. Three address pins A0, A1 and A2 are used for the I2C-bus without additional hardware. Address, control and data to be transmitted via the two-line bidirectional I2C-bus.
Features:
- Single power supply
- Operating power voltage 2.5 V to 6 V
- Low standby current
- Serial input / output via I2C-bus
- Address by 3 hardware address pins
- Sampling rate given by I2C-bus speed
- 4 analog inputs programmable as single-ended or differential inputs
- Auto-incremented channel selection
- Analog voltage range from VSS to VDD
- On-chip track and hold circuit
- 8-bit successive approximation A / D conversion
- Multiplying DAC with one analog output.
22793
Other products in the same category (16)
Fully programmable card (PICC) emulator, simulator to characterize, test and certify contactless readers for ISO 14443, ISO 15693, NFC and FeliCa conformity
Retired
No product available!
BleBox tempSensor is a miniature temperature sensor that allows it to be monitored by WiFi. Allows you to measure temperatures in the range of -55 to + 125 degrees Celsius (with an accuracy of ± 0.5°C)
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
Insulated fibre-optic probe with a measurement range of up to 1000 V. Operates up to 1 GHz and can be connected to an oscilloscope via a BNC connector. Battery-powered. Micsig OIP1000B
Retired
No product available!
No product available!
The expansion module is designed to work with a portable computer built into the Raspberry Pi 400 keyboard. The board has two 40-pin connectors placed in a vertical position and a connector for RPI 400 at an angle of 45 °. Waveshare PI400-GPIO-ADAPTER-C
Retired
No product available!
No product available!
No product available!
Low voltage alarm for LiPo 2s ~ 3s packets (HK22749)
Retired
No product available!
The RGB LED ruler has 8 programmable LEDs WS2812B with a built-in control system. It is possible to set a specific color for each diode. The module has an IN input for controlling and an OUT output to which further light points or other modules from WS2812B can be connected. The supply voltage is from 3.5 to 5.3 V, and the input voltage +/- 0.5 V of the supply voltage
Retired
No product available!
No product available!
No product available!
The SparkFun Qwiic Shield for Arduino Nano allows you to add the SparkFun Qwiic ecosystem to development boards that use the Arduino Nano Footprint in an easy-to-assemble shield. It connects the I2C bus (GND, 3.3V, SDA, and SCL) on your Arduino Nano to four SparkFun Qwiic connectors.
Retired
No product available!
8-bit A / D and D / A converter, DIP16, RoHS