AD9833BRM

The Cloudshell for XU4 is an affordable DIY Network Attached Storage (NAS) Solution to create your own personal cloud! It includes a color LCD console display on the front and has room for a 2.5inch HDD/SSD along with the XU4 board inside the CloudShell

The Cloudshell for XU4 is an affordable DIY Network Attached Storage (NAS) Solution to create your own personal cloud! It includes a color LCD console display on the front and has room for a 2.5inch HDD/SSD along with the XU4 board inside the CloudShell

Cooling Fan X is a cooling fan that can be used to cool any processor that works under heavy load. It can be mounted on the heat sink housing with 4 screws

Photon Wearable Shield makes it easy to add the WiFi enabled Photon to any wearables project. Each pin on the Photon is broken out into large sewing pins. Use conductive thread to make your next wearables projects. DEV-13328

The cable allows connecting the ATMEL-ICE programmer to the commissioning set with any connector (operated by the programmer), through individual pin connectors

1-channel monochrome system of adding subtitles on the image (OSD - On-Screen Display) with integrated EEPROM, TSSOP28, Maxim memory

John Baichtal

The controller can control two brush motors, communicating with the master system using USB Micro-B, TTL serial interface, analog signals, as well as signals from the RC apparatus. The current capacity of 5A / channel allows you to control high-power motors. Polol 2394

EEPROM CAT93C86LI-G memory; 16kbit; 2K x 8bit; access time: 150ns; Power supply: 1.8 ... 5.5 V; 8-Pin PDIP

Nettemp Pi Hat is a module that allows to connect eight trees of sensors with I2C/1-Wire interface and control of four relays outputs. Thanks to the extension board is possible to build in an easy way e.g. a multipunkt temperature controller.

32GB microSDHC Memory Card with SD Adapter, class 10 A1, Kingston

WiFi 802.11 b / g / n module with ESP8266 system, 5 leads are available with 2 mm pitch with the possibility of soldering of gold pins, power lines, reset line and UART interface have been led to the connector. 3.3V power supply

WiFi 802.11 b / g / n module with ESP8266 system, 8 pins with 2.54 mm pitch are available with soldered gold pins, 3 GPIO lines, reset, power supply and UART interface on the connector. U.FL. Antenna Connector 3.3 V power supply

nRF51 DK is a development board based on the nRF51422 system with Bluetooth Low Energy (BLE) and 2.4 GHz connectivity. The module has a connector compatible with Arduino shields, buttons and diodes available to the user.

Marco Schwartz

Andrzej Stasiewicz