JTAG SMT2 NC (410-308)

JTAG-SMT2-NC Surface-Mount Programming Module

Description:

Small, complete, surface-mounted programming module for FPGA. The module can be used with Xilinx tools, including iMPACT, ChipScope ™ and EDK.

The user can place this module on the target board. JTAG-SMT2-NC uses 3.3V supply voltage and a separate reference voltage for JTAG signals. All JTAG signals use three-state buffers that allow operation with voltages of 1.8 V to 5 V and bus speeds up to 30 MBits / second. In addition to the programming time, the JTAG outputs from the programmer are kept in a high impedance state, so they can be used.

Features:

• Small, complete, multifunctional solution for programming / debugging Xilinx FPGA systems
• Compatible with all Xilinx tools
• Compatible with IEEE 1149.7-2009 T0 - T4 classes (including two-wire JTAG)
• The GPIO pin allows debugging to reset the Xilinx Zynq processor core
• A single 3.3V power supply
• Separate reference voltage Vref controls the voltage of the JTAG line; Vref voltage is in the 1.8V - 5V range.
• It is possible to install the programmer directly on the board
• USB signals D + and D- lead out on the pads, allowing you to connect the USB connector in an established place on the programmed disc.

Code: 410-308P