- Out-of-Stock
The DA/AD module is specifically designed for BananaPi. It communicated with BananaPi through I2C bus. There is a LED light on the board that you can adjust brightness through DA. The module supply 4 ADC channel through header on the left side of module and the thermistor interface. The user can choose according to actual demand and use them. The module is easy to use even you don’t need to write C code. Because the module support wiringPi so you can use shell script to control it.
The PCF8591 is a single-chip, single-supply low-power 8-bit CMOS data acquisition device with four analog inputs, one analog output and a serial I2C bus interface. Three address pins A0, A1 and A2 are used for programming the hardware address, allowing the use of up to eight devices connected to the I2C bus without additional hardware.
Address, control and data to and from the device are transferred serially via the two-line bidirectional I2C bus. The functions of the device include analog input multiplexing, on-chip track and hold function, 8-bit analog-to-digital conversion and an 8-bit digital-to-analog conversion. The maximum conversion rate is given by the maximum speed of the I2C bus.
Ports
Product parameters
Typical applications
No product available!
Module with a relay with a permissible maximum current of 10A with a 5V coil (MOD-03.Z). The module has a transistor relay control transistor and an overvoltage / self-inductive diode from the coil.
No product available!
The converter enables simple connection of the project being built with the UART output to the computer via a USB interface. After connecting to a computer, a virtual COM port is created. MOD-05 / AZ
No product available!
No product available!
The stabilizer module is used to stabilize the output voltage at an appropriate level and filter interference. The module can be supplied with voltage up to + 16V, and the output voltage is + 3.3V. MOD-06 / 3V3.Z
No product available!
The stabilizer module is used to stabilize the output voltage at an appropriate level and filter interference. The module can be supplied with voltage up to + 16V, and the output voltage is + 5V. MOD-06 / 5V.Z
No product available!
The stabilizer module is used to stabilize the output voltage at an appropriate level and filter interference. The module can be supplied with voltage up to + 16V, and the output voltage is + 9V. MOD-06 / 9V.Z
No product available!
The stabilizer module is used to stabilize the output voltage at an appropriate level and filter interference. The module can be supplied with voltage up to + 16V, and the output voltage is + 12V.
No product available!
No product available!
No product available!
MT SPEC01 / 2015 RASPBERRY, ISSN 0462-9760
No product available!
Dustyn Roberts
No product available!
Atmel SMART SAM V71 Xplained Ultra development kit with ATSAMV71Q21 microcontroller with ARM Cortex-M7 core. ATSAMV71-XULT
No product available!
No product available!
No product available!
The module with the 74LVC245AD system allows connecting systems with different supply voltages. Bi-directional operation mode allows you to change the output to the input using a jumper or DIR input, without the need to disconnect the system. MOD-12.Z
No product available!
BPI AD/DA extend module with the PCF8591 single-chip, single-supply low-power 8-bit CMOS data acquisition device with four analog inputs, one analog output and a serial I2C-bus interface