- Out-of-Stock

A system with a gracefully named lamp-click is a real LED light that is turned on and off by clapping hands. After installing it in a child's room, it will allow to amaze colleagues and family.
The system reacts to a single clap in the hands. At the same time, it displays the minimum sensitivity to the sounds typical of the environment, music, barking of a dog, etc. Each subsequent release changes the output status of the integrated circuit to the opposite, switching on or off the white LED with increased brightness. After the power is turned on, the system is reset and remains in standby mode until it is clasped in the hands, regardless of the operating status it consumes little energy from the battery. The printed circuit board has been designed to fit on the battery basket.
Project AVT 788 EdW 11/16
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
No product available!
The switch module has a relay with a control function via a WiFi network. It can be connected to a WiFi network or act as a stand-alone access point. Shelly 1 Open Source
No product available!
No product available!
No product available!
Needle bending needle, for precise glue application, Flux 0.84mm internal diameter and 1,26mm outside diameter
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
CR2016 lithium battery with 3V voltage and 75mAh capacity. Tecxus CR2016
No product available!
No product available!
The GPIO Expander board allows you to extend the project with an additional 16 I / O signal lines, equipped with an MCP23017 chip with an I2C interface. MOD-67
No product available!
No product available!
A stereo tube preamplifier based on 6K4 tubes. Designed for use with active speakers or an additional amplifier and passive speakers. FX-AUDIO Tube-03
No product available!
Graphic LCD 160x32, 135x40mm, LED backlight yellow/green, (v.C) ST7920 controller, character generator
No product available!
PCB board for LED lamp responding to the clap - lamp-click. AVT788 A