Orange Pi ABS Case for Orange Pi Plus 2e – Transparent

Spring dedicated to the heating table of 3D printers. It allows you to adjust the degree of tightening the knob, and thus enables the proper leveling of the working table

Spring dedicated to the heating table of 3D printers. It allows you to adjust the degree of tightening the knob, and thus enables the proper leveling of the working table

A portable Smart oscilloscope with an 8-inch LCD display and a touch screen. It has two measurement channels and has good measurement parameters: 200 MHz band, 2 GSa/s sampling rate and 280 Mpts memory buffer. Micsig STO2202C

A portable Smart oscilloscope with an 8-inch LCD display and a touch screen. It has two measurement channels and has good measurement parameters: 150 MHz band, 1 GSa/s sampling rate and 70 Mpts memory buffer. Micsig STO1152E

Industrial RS485 - Ethernet converter. It is equipped with PoE function and is DIN-rail mounted. Waveshare RS485 TO POE ETH (LF)

10.3" monitor with e-Paper screen equipped with a mini HDMI interface. It offers a resolution of 1872×1404 pixels, a wide viewing angle and low power consumption. Waveshare EINK-DISP-103B (EU)

9.7" monitor with e-Paper screen equipped with a mini HDMI interface. It offers a resolution of 1200x825 pixels, a wide viewing angle and low power consumption. Waveshare EINK-DISP-97 (EU)

A portable gaming console based on the Raspberry Pi Zero, featuring a 2" IPS LCD display and speaker. Waveshare GamePi20 Acce

High voltage differential probe. It is characterized by good measurement parameters: 100 MHz band and working voltage up to 750 V. The probe has two attenuation factors: 50X and 500X and uses the UPI interface. Micsig DP750-100

High voltage differential probe. It is characterized by good measurement parameters: with a 100 MHz band and an operating voltage up to 5600 V. The probe has two attenuation factors: 200X and 2000X. Micsig DP20003

Probe for measuring direct and alternating current with a current of up to 30 A. Works in the band up to 100 MHz, it can be connected to the oscilloscope through the UPI connector. It does not require an external power supply. Micsig CP1003

Probe for measuring direct and alternating current with a current of up to 30 A. Works in the band up to 50 MHz, it can be connected to the oscilloscope through the UPI connector. It does not require an external power supply. Micsig CP503

Self-assembly case designed for minicomputers Odroid H3 and Odroid H3+. Equipped with a place for a network card. Hardkernel ODROID-H3 Case Type 6

The expansion board is designed to work with Alchitry Au and Alchitry Cu. The board has four 7-segment LED displays, five buttons, 24 LEDs and 24 DIP switches. SparkFun DEV-17278

Minicomputer with Amlogic S922X processor, which integrates the ARM Cortex-A73 quad-core chip and Cortex-A53 dual-core with Mali-G52 GPU and 4GB of RAM. Additional equipment includes: eMMC memory slot, HDMI, microSD card slot and 40-pin GPIO connector. Hardkernel Odroid N2L

Minicomputer with Amlogic S922X processor, which integrates the ARM Cortex-A73 quad-core chip and Cortex-A53 dual-core with Mali-G52 GPU and 2GB of RAM. Additional equipment includes: eMMC memory slot, HDMI, microSD card slot and 40-pin GPIO connector. Hardkernel Odroid N2L