- Out-of-Stock
zł30.52
B-L072Z-LRWAN1
ID: 565486
5906623410125
STM32L0 Discovery kit LoRa, low-power wireless. B-L072Z-LRWAN1
Description
The B-L072Z-LRWAN1 LoRa®Discovery kit is a development tool to learn and develop solutions based on LoRa®and FSK/OOK technologies. This Discovery kit features an all-in-one open module CMWX1ZZABZ-091 (by Murata). The module is powered by an STM32L072CZ and an SX1276 transceiver. The transceiver features the LoRa®long-range modem, providing ultra-long-range spread spectrum communication and high interference immunity, minimizing current consumption. Since CMWX1ZZABZ-091 is an open module, user has access to all STM32L072 peripherals such as ADC, 16-bit timer, LP-UART, I2C, SPI and USB 2.0 FS (supporting BCD and LPM).
The B-L072Z-LRWAN1 Discovery kit includes an ST-LINK/V2-1 embedded debug tool interface, LEDs, push-buttons, antenna, Arduino™Uno V3 connectors and USB OTG connector in Micro-B format.
The LoRaWAN™stack is certified class A and C compliant. It is available inI-CUBE-LRWAN firmware package. Several examples, as an AT-command stack, are available to help users setting up a complete LoRaWAN™node.
Features
- CMWX1ZZABZ-091 LoRa® module (Murata)
- Embedded ultra-low-power STM32L072CZ Series MCUs, based on ARM® Cortex® -M0+ core, with 192 Kbytes of Flash memory, 20 Kbytes of RAM, 20 Kbytes of EEPROM
- USB 2.0 FS
- 4-channel,12-bit ADC, 2xDAC
- 6-bit timers, LP-UART, I2 C and SPI
- Embedded SX1276 transceiver
- LoRa® , FSK, GFSK, MSK, GMSK and OOK modulations
- +14 dBm or +20 dBm selectable output power
- 157 dB maximum link budget
- Programmable bit rate up to 300 Kbit/s
- High sensitivity: down to -137 dBm
- Bullet-proof front end: IIP3 = -12.5 dBm
- 89 dB blocking immunity
- Low RX current of 10 mA, 200 nA register retention
- Fully integrated synthesizer with a resolution of 61 Hz
- Built-in bit synchronizer for clock recovery
- Sync word recognition
- Preamble detection
- 127 dB+ dynamic range RSSI
- SMA and U.FL RF interface connectors
- Including 50 Ohm SMA RF antenna
- On-board ST-LINK/V2-1 supporting USB re-enumeration capability
- USB ST-LINK functions:
- Board power supply:
- Through USB bus or external VIN /3.3 V supply voltage or batteries
- 3xAAA-type-battery holder for standalone operation
- 7 LEDs:
- 4 general-purpose LEDs
- A 5 V-power LED
- An ST-LINK-communication LED
- A fault-power LED
- 2 push-buttons (user and reset)
- Arduino™ Uno V3 connectors
- ARM® mbed™ (see http://mbed.org)
565486
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
The B-L475E-IOT01A Discovery kit for IoT node allows users to develop applications with direct connection to cloud servers. The Discovery kit enables a wide diversity of applications by exploiting low-power communication, multiway sensing and Arm® Cortex® -M4 core-based STM32L4 Series features
zł286.44
24h
Available quantity: 2
Available
The Discovery kit enables a wide diversity of applications by exploiting low-power communication, multiway sensing and Arm® Cortex® -M4 core-based STM32L4 Series features
zł309.80
24h
Available quantity: 3
Available
Other products in the same category (16)
EEPROM CAT93C86LI-G memory; 16kbit; 2K x 8bit; access time: 150ns; Power supply: 1.8 ... 5.5 V; 8-Pin PDIP
Retired
No product available!
Nettemp Pi Hat is a module that allows to connect eight trees of sensors with I2C/1-Wire interface and control of four relays outputs. Thanks to the extension board is possible to build in an easy way e.g. a multipunkt temperature controller.
Retired
No product available!
32GB microSDHC Memory Card with SD Adapter, class 10 A1, Kingston
Retired
No product available!
WiFi 802.11 b / g / n module with ESP8266 system, 5 leads are available with 2 mm pitch with the possibility of soldering of gold pins, power lines, reset line and UART interface have been led to the connector. 3.3V power supply
Retired
No product available!
WiFi 802.11 b / g / n module with ESP8266 system, 8 pins with 2.54 mm pitch are available with soldered gold pins, 3 GPIO lines, reset, power supply and UART interface on the connector. U.FL. Antenna Connector 3.3 V power supply
Retired
No product available!
nRF51 DK is a development board based on the nRF51422 system with Bluetooth Low Energy (BLE) and 2.4 GHz connectivity. The module has a connector compatible with Arduino shields, buttons and diodes available to the user.
Retired
No product available!
No product available!
No product available!
Featuring a quad-core Amlogic processor, advanced Mali GPU, and Gigabit Ethernet
Retired
No product available!
The case has openings for all outputs including the GPIO port making it a great fit for projects that are connected to external hardware.
Retired
No product available!
The case has openings for all outputs including the GPIO port making it a great fit for projects that are connected to external hardware.
Retired
No product available!
Super charged single board computer with an Octa-core processor and 2GB of RAM. Along side the elite processing unit, it features Gigabit Ethernet, 2 USB, SATA, WiFi, Bluetooth, and HDMI connection. It can run on a variety of operating systems including Android, Lubuntu, Ubuntu, Debian, and Raspbian
Retired
No product available!
Works with the ODROID-C2 / C0 / C1+. The HiFi Shield provides both stereo RCA connectors and a 3.5mm stereo jack (all gold-plated) to connect to external amplifiers and other audio equipment
Retired
No product available!
No product available!
This rev of the RS232 Shield provides with the option to choose between two pins from an Arduino (D0 to D7) as software serial ports to communicate with RS232 Shield. DEV-13029
Retired
No product available!
The HSPA / GSM modem card with the miniPCIe connector allows to obtain 14.4 Mbps "up" transmission speed and 5.76 Mb / s "down" transmission, working on four ranges. HUAWEI MU609
Retired
No product available!
STM32L0 Discovery kit LoRa, low-power wireless. B-L072Z-LRWAN1