- Out-of-Stock
AVT3233 C - a balanced power supply for audio amplifiers. Assembled set
ID: 572317
Assembled symmetrical power supply for audio amplifiers. AVT3233 C
Description
Amplifiers with power above a dozen or so watts require a power supply supplying two voltages (i.e., symmetrical voltage). The presented system is a simple power supply that allows you to work with audio amplifiers up to 100W. The module can be a complement to the self-built audio system. It allows you to make a non-stabilized power supply with a maximum output current of up to 6A.
Project AVT 3233 EdW 08/18
Attention! Electrolytic capacitors connected to a voltage higher than their rated voltage and reversed, may explode, posing a serious health risk! There are dangerous voltages for health and life in the power supply, which may persist for a long time after the power supply has been disconnected. Before connecting the amplifier to the power supply, make sure that the capacitors C5 ... C10 are discharged.
Included
- Assembled set
572317
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
No product available!
No product available!
Infrared thermometer module. It is characterized by high sensitivity and accuracy, low noise and low energy consumption. DFRobot SEN0093
Retired
No product available!
9.7" monitor with e-Paper screen equipped with a mini HDMI interface. It offers a resolution of 1200x825 pixels, a wide viewing angle and low power consumption. Waveshare EINK-DISP-97 (EU)
Retired
No product available!
No product available!
Printed circuit board and programmed system for the alarm control panel cooperating with the motion sensor. AVT1925 A +
Retired
No product available!
No product available!
50 cm long power cord terminated on both ends with a 5.5x2.5mm DC Jack plug. It allows you to connect a battery or a power supply with a DC socket to the TS100 soldering iron. Miniware DC5525 is DC5525 Cable
Retired
No product available!
No product available!
NanoPi NEO Core is a small PCB equipped with the SoC Allwinner H3 chip and 512MB RAM. The GPIO port has been moved, among others Ethernet, USB, SPI, UART, I2C, I2S interface. The board can be powered from the Micro USB connector. FriendlyELEC NanoPi NEO Core
Retired
No product available!
No product available!
A liquid for cleaning printed circuit boards based on isopropyl alcohol, perfectly removes binder residues, as well as lubricants and oils
Retired
No product available!
Waveshare WIFI232 Eval Kit is an evaluation board WIFI501 with WIFI232-B module. The board has a USB - UART converter, a reload button, an RJ45 ethernet interface connector and an RS485 interface connector. Waveshare WIFI232 Eval Kit
Retired
No product available!
No product available!
Brass heat sink with RPi logo for Raspberry Pi 4 model B minicomputers. Equipped with self-adhesive tape for easy installation
Retired
No product available!
No product available!
Assembled symmetrical power supply for audio amplifiers. AVT3233 C