- Out-of-Stock
AVT5638 A + - a miniature reminder. PCB and programmed layout
ID: 572367
Printed circuit board and programmed layout for a miniature reminder. AVT5638 A +
Free shipping
free shipping in Poland for all orders over 500 PLN
Same day shipping
If your payment will be credited to our account by 11:00
14 days for return
Each consumer can return the purchased goods within 14 days
Description
This small device has been designed, above all, for diabetic care, but you can find a much wider range of applications for it. Its task is to signal the passage of a previously set time interval, measured from pressing a button. In this way, it is possible to remind about the need to measure the level of glucose in the blood after some time from the meal, or to look into the boiler room after some time from firing in the oven.
Project AVT 5638 EP 08/18
properties
- Power from a 3V lithium battery
- Power consumption: in standby mode 0.5 mA, in the active state 8 mA, in the alarm state 7 mA
- Measuring one of 4 predefined times: 15 minutes, 30 minutes, 1 hour, 2 hours
- Timing triggered by the button
- Time set by the DIP-SWITCH switch
- ATtiny12A microcontroller, software in C language
Included
- PCB board and programmed layout
572367
Other products in the same category (16)
0.1" (2.54mm) Crimp Connector Housing: 1x10-Pin 5-Pack
Retired
No product available!
No product available!
No product available!
No product available!
Set of six precision antimagnetic tweezers in stainless steel, acid resistant, RoHS
Retired
No product available!
No product available!
No product available!
Aluminum extensometer beam, allowing measurement of weight up to 20 kilograms. It has four wires. It is used in kitchen scales and portable scales, max. 20 kg, dimensions: 80x7x7 mm, has a 21 cm cable. Tensom20kg02
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
24h
Available quantity: 1
Meet the Roadster MK3 from the 2.5D Classic Vehicles collection—the first series in our new line of Ugears 2.5D puzzles! This beautiful DIY 2.5D wooden picture model has movable elements and comes in its own frame, suitable for hanging on a wall or standing on a desk or shelf. The Roadster MK3 depicts a classically-styled muscle car, and will be an attractive addition to your home or office decor. This automotive picture model comes to life with a side door that opens, wheels that turn, hood and boot that open and close, and a movable stick shifter. UGears 70195
Retired
No product available!
No product available!
Development kit with STM32F401VCT6 microcontroller (256 kB Flash, 64 kB RAM, LQFP100 housing) and a built-in programmer / debugger ST-Link v. 2. Additional equipment are: a gyroscope (L3GD20), an accelerometer with a magnetometer (LSM303DLHC), a microphone (MP45DT02) and D / A converter with amplifier (CS43L22).
Retired
No product available!
Printed circuit board and programmed layout for a miniature reminder. AVT5638 A +