Official HDMI 2.0 cable for Raspberry Pi (Black)

The module enables connection of two devices with I2C interface working with different voltage levels. MOD-28.Z

It is used to monitor the temperature measurement and other parameters. The expansion module has an I2C / 1-Wire converter (DS2482) through which DS18B20 temperature sensors can be connected using two or three wires. MOD-29.Z

Power module with IRFR4105Z transistor (MOD-30.Z), maximum current 2A, 5V power supply or 5V - 12V range (selection by jumper)

The module with the DS18B20 sensor is used to measure the temperature in the range from -55° C to + 125° C, with an accuracy of +/- 0.5° C in the range from -10° C to + 85° C. The module communicates via the 1-Wire interface, thanks to which it can be connected using 2 or 3 wires - depending on the configuration. Temperature measurement can be performed with an accuracy of 9 to 12 bits. MOD-31.Z

Universal module with LM358 operational amplifier. Depending on the additional elements installed, the amplifier can be freely configured, eg as a reversing, non-inverting amplifier, voltage follower or an integrating amplifier. MOD-32.Z

MOD-33 / AZ

The modally controlled modulation module MOD-34 / BZ allows wireless load control with a current consumption of up to 10A via a relay. Includes wireless module nRF24l01.

MOD-35.Due

MOD-36.Z

MOD-37.Z

The module with the TXB0108 system enables the connection of systems operating with different voltage levels. It has 8-channels and is 2-way. The transmission direction of each channel is detected automatically. MOD-38.Z

MOD-39.Z

The STM32 eXploreM0 module contains a 32-bit microcontroller with ARM Cortex M0 core, STM32F051C8T6 (64 kB Flash memory, 8 kB RAM, 48 MHz, HDMI-CEC, I2C, IrDA, LIN, SPI, UART / USART). The USB / UART converter allows programming of the microcontroller via a USB cable. MOD-40.Z

The STM32 eXploreM0 + module contains a 32-bit microcontroller with ARM Cortex M0 + core, STM32L051C8T6 (64 kB of Flash memory, 8 kB RAM, 32 MHz, I2C, IrDA, SPI, UART / USART). The built-in USB / UART converter enables programming of the microcontroller via a USB cable. MOD-41.Z

MOD-44.Z

The RGB LED ruler has 8 programmable LEDs WS2812B with a built-in control system. It is possible to set a specific color for each diode. The module has an IN input for controlling and an OUT output to which further light points or other modules from WS2812B can be connected. The supply voltage is from 3.5 to 5.3 V, and the input voltage +/- 0.5 V of the supply voltage