WEP 992D 75W Hot air / grotter Rework Station

Description

WEP 992D is a 2in1 soldering station that connects a hot air soldering iron with a soldering iron. The station is equipped with an advanced PID controller correcting the temperature every 20 ms, allowing to obtain a stable temperature, even when soldering large parts with a soldering iron. Original Japanese Hakko heating elements make the soldering iron warm up in less than 1 minute. The station is equipped with a readable LCD display showing the current temperature of the soldering irons and the power of the blow. The temperature can be set using the buttons, while the power of the blast is put in a convenient potentiometer. The soldering iron is equipped with an automatic cooling function when the soldering iron is not used, in the case of a hot air soldering iron the breaker is in the handle, so after the soldering iron is automatically cooled, in the case of a soldering iron you can set the time after which the soldering iron cools down to 200 ºC , which significantly extends the life of the heater. The built-in error control system will inform the user through a message on the display in the event of a short circuit, overloading of circuits or failure to achieve the desired temperature. A wide range of available tips allows soldering not only leaded components, but also SMD in housings such as QFP, SOIC or PLCC, while a hot air solder compatible with many nozzles will work perfectly when soldering components in more demanding cases such as BGA.

Specification

• PID controller correcting the temperature every 20 ms
• Microprocessor control of parameters: temperature, power of blowing, working time
• Compact design with a legible LCD display
• Temperature display mode ° F / ° C
• Properties of the hot air soldering iron
  • Air flow source: fan built into the flask
  • Air flow: up to 120 l / min
  • Temperature range: 100-480 ° C
  • Temperature stability: 1 ° C
  • Cord length: 100 cm
  • Protection against reaching too high temperature and informing by alarm
  • Automatic cooling mode of the flask after putting it back in the holder
  • Displays the actual blowing power
• Properties of the soldering iron
  • Temperature range: 200 - 480 ° C
  • Temperature stability: 1 ° C
  • Heating power: 75 W
  • Original Hakko heating element of Japanese production
  • Grounding resistance below 2 ohms
  • Ground potential below 2 mV
  • System: ESD safe
  • The length of the flask wire: 100 cm
  • Sleep mode: switched on after idle operation 0-99 minutes (value 0 disables the function)

Included

• WEP 992D soldering station
• Handle a hotair flask
• Nozzle set:
  • Round nozzle with diameter 4.4 mm 1130
  • Round nozzle with a diameter of 7 mm 1196
  • Round nozzle with a diameter of 9 mm 1197
  • Square nozzle 12x12 mm 1313
• A stand for a tipped flask with cleaning sponge and cleaner
• Graduated flask 907I with T-B conical grip
• Gripper for lifting systems
• Power cord