- Out-of-Stock

Leszek Pawlaczyk, Zdzisław Załoga
The study contains a detailed discussion of 14 laboratory exercises from power electronics, which can be implemented in any range, depending on the software requirements.
Each discussion is used to repeat, extend and consolidate the messages conveyed during the lectures and to prepare for the exercise in practice at the laboratory stand.
Table of Contents
Preface
List of markings
1. Thyristor testing
2. Testing of a single-phase AC controller
3. Testing of three-phase AC controller
4. Study of a thyristor DC chopper
5. Test of one pulse rectifier
6. Examination of a two-pulse rectifier
7. Examination of the three-pulse rectifier
8. Testing of a six-pulse rectifier
9. Testing of a single-phase serial commutator inverter
10. Testing of a three phase phase switching inverter
11. Investigation of cooperation of a voltage inverter with external AC voltage source
12. Testing of a DC impulse driver
13. Test of three-phase voltage inverter with pulse width modulation
14. Research on thyristor control and triggering systems
15. Final remarks
Literature.
No product available!
Module with e-Paper display, 7.3" diagonal and 800x480 px resolution. Communication via SPI interface. Waveshare 7.3inch e-Paper HAT (G)
No product available!
Music Shield for Arduino Development, Audio Play/Record, VS1053B Onboard
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
Dispensing needle for precise application of glue, flux with an internal diameter of 0.84mm and an external diameter of 1.25mm.
No product available!
Female terminal block, 4-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-4P
No product available!
Permanent cylindrical neodymium magnet with a diameter of 12 mm and a height of 3 mm.
No product available!
No product available!
No product available!
No product available!
120:1 Plastic Gearmotor Offset OutputPlastic gear motor 120:1, operating voltage 6 V, current consumption from 0.07 A to 0.8 A, speed 85 RPM and maximum torque of 5.4 kg*cm. Pololu 1119
No product available!
Leszek Pawlaczyk, Zdzisław Załoga