STLINK-V3SET - STLINK-V3 modular in-circuit debugger and programmer for STM32/STM8

 Description

The STLINK-V3SET is a modular stand-alone debugging and programming probe for the STM8 and STM32 microcontrollers. It is composed of a main module and a complementary adapter board.

The SWIM and JTAG/SWD interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.

The STLINK-V3SET also provides a Virtual COM port interface allowing the host PC to communicate with the target microcontroller through one UART, and bridge interfaces (SPI, I²C, CAN, GPIOs) allowing for instance the programming of the target through bootloader.

The modular architecture of STLINK-V3SET enables to extend its main features through additional modules such as the adapter board.

 Features

• Stand-alone probe with modular extensions
• Self-powered through a USB connector (Micro-B)
• USB 2.0 high-speed compatible interface
• Direct firmware update support (DFU)
• JTAG / serial wire debugging (SWD) specific features:
  • 3 V to 3.6 V application voltage support and 5 V tolerant inputs
  • Flat cables STDC14 to MIPI10 / STDC14 / MIPI20 (connectors with 1.27 mm pitch)
  • JTAG communication support
  • SWD and serial wire viewer (SWV) communication support
• SWIM specific features (only available with adapter board MB1440):
  • 1.65 V to 5.5 V application voltage support
  • SWIM header (2.54 mm pitch)
  • SWIM low-speed and high-speed modes support
• Virtual COM port (VCP) specific features:
  • 3 V to 3.6 V application voltage support on the UART interface and 5 V tolerant inputs
  • VCP frequency up to 15 MHz
  • Available on STDC14 debug connector (not available on MIPI10)
• Multi-path bridge USB to SPI/UART/I²C/CAN/GPIOs specific features:
  • 3 V to 3.6 V application voltage support and 5 V tolerant inputs
  • Signals available on adapter board only (MB1440)
• Drag-and-drop Flash programming
• Two color LEDs: communication, power