Waveshare CC Debugger - programator / debuger układów TI CCxxxx
search
  • Waveshare CC Debugger - programator / debuger układów TI CCxxxx
  • Waveshare CC Debugger - programator / debuger układów TI CCxxxx
  • Waveshare CC Debugger - programator / debuger układów TI CCxxxx
ID: 563245
5906623421800
zł123.27
Tax included

zł100.22 tax excl.

Debugger and Programmer for CCxxxx RF System-on-Chip (SoC) devices, CCxxxx RF transceivers, and CC85xx devices with PurePath Wireless Configurator

24h
Available
Available quantity: 5
Kamami is the official distributor of Waveshare displays, accessories and modules.

Description

The CC Debugger is primarily used for debugging and programming the flash on CCxxxx 8051-based System-on-Chip (SoC) devices from Texas Instruments. CC Debugger also supports CCxxxx RF transceivers. In addition, CC Debugger is used for configuring the CC85xx devices with PurePath Wireless Configurator.

Key Features

  • Performance
    • Compatible with the original TI CC Debugger
    • Supported Operating Systems: Windows 2000, Windows xp sp2/sp3, Windows Vista 32bit, Windows 7 32bit
    • Target voltage: 1.2V~3.6V
    • Capable of powering the target board from the debugger
    • Operating temperature: 0?~85?
  • Supported Software
    • IAR Embedded Workbench For C8051
    • SmartRF Flash Programmer
    • SmartRF Studio
    • SmartRF Packet Sniffer
    • PurePath Wireless Configurator
  • Connects to PC
    • Computer connection via USB interface
  • Connects to target board
    • Target board connection via 10-pin IDC connector (2x5 2.54mm pitch). The figure below shows the header pinout:CC Debugger header pinout

Supported Devices

  • Programming and debugging the following 8051-based system-on-chips from Texas Instruments:
    • CC1110, CC1111
    • CC2430, CC2431
    • CC2510, CC2511
    • CC2530, CC2531, CC2533
    • CC2540, CC2541
    • CC2543, CC2544, CC2545
  • Controlling the following transceivers from SmartRF Studio:
    • CC1120, CC1121, CC1125, CC1175
    • CC1101, CC110L, CC113L, CC115L
    • CC2520
  • Configuring the CC85xx devices with PurePath Wireless Configurator:
    • CC8520, CC8521
    • CC8530, CC8531

LED Status

  • OFF: The debugger has no power or there is no valid firmware on the debugger.
  • AMBER (BOTH LEDS ON): The debugger is powered, but there is no valid firmware.
  • RED LED BLINKING: The Debugger is in Boot Recovery Mode.
  • RED LED ON: No device detected. This might be due to old firmware on the CC Debugger, or a problem with the hardware connection (make sure the target board is properly powered and connected correctly).
  • GREEN LED ON: The target device has been properly detected. It is possible to start programming/debugging.

Package Includes

Weight: 0.121 kg

  1. CC Debugger × 1
  2. USB cable × 1
  3. 10-pin flat cable × 1

563245

Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20

Other products in the same category (7)