WiFi module with ESP8266 (NodeMCU)
ID: 570607
5906623482399
zł55.94
Tax included
zł45.48 tax excl.
WiFi module based on ESP8266. It has an embedded antenna and 0.96 "OLED display. The module can be programmed in Lua (under NodeMCU firmware control) or in the Arduino IDE. Provides 12 GPIO lines.
Description
WiFi module based on ESP8266 with embedded antenna and 0.96 "OLED display. 12 GPIO lines are available to the user, each of these lines can be used as an I2C interface line, 1-Wire or as a PWM line. The module can work under NodeMCU firmware control, also has support in the Arduino IDE.
Features
- Module based on ESP8266 with an embedded antenna
- Frequency: 2.4 GHz
- WiFi standard - 802.11 b/g/n
- Transmitted power level: +25 dBm
- 0.96 "OLED display
- 12 GPIO/I2C/1-Wire/PWM lines
- Module lines lead out to goldpin 2.54mm connector (no pins included)
- Compatible with the Arduino IDE environment
Kit contains
- WiFi NodeMCU module with ESP8266
- Goldpin 10-pin connector
- Goldpin 16-pin connector
570607
Data sheet
- Logic voltage
- 3,3 V
- Wi-Fi chip
- ESP8266
- Wi-Fi standard
- 802.11 b/g/n
- Frequency range
- 2,4 GHz
- Baud rate
- 72,2 Mbps
- Antenna connector
- Brak
- Power supply voltage
- 5 V
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
WiFi 802.11 b/g/n module with ESP8266 system, they have 22 edge terminals with 2 mm raster with the possibility of soldered gold connectors, 9 GPIO lines and 1 ADC line on the connector. Built-in PCB antenna. ESP-12E
zł9.25
24h
Available quantity: 85
Available
WiFi module based on ESP8266. The module has a built-in antenna and USB-UART converter. The module can be programmed in Lua (under the control of the NodeMCU firmware) or in the Arduino environment. 10 GPIO lines are available which each can be configured to work as PWM, I2C.
zł19.48
24h
Available quantity: 30
Available
Plate for applications in the area of Internet of Things (IoT). The module was based on the ESP8266 system, which integrates WiFi, TCP / IP communication, 32-bit MCU, 10-bit ADC and many interfaces such as HSPI, UART, PWM, I2C and I2S. DFrobot DFR0489
zł37.75
24h
Available quantity: 2
Available
Other products in the same category (16)
The IoT module combining Wi-Fi and Bluetooth (BLE) technologies, which is designed for a wide range of applications, from low-power sensor networks to the most demanding tasks such as voice coding, music streaming and MP3 decoding. Espressif ESP32-WROOM-32D 128MBit
zł32.90
1 weeks
No product available!
A small evaluation board with nRF52840 (ARM Cortex-M4) and WiFi ESP32-D0WD module for projects related to Mesh networks. Adafruit 3997
zł256.95
24h
Available quantity: 2
Available
Module from the ESP32 series, combining a powerful microcontroller, Wi-Fi and Bluetooth 4.2 BLE. ESP-WROVER-B has a built-in PCB antenna, a large number of GPIO lines and small dimensions. Adafruit 3979
zł55.12
4 weeks
No product available!
Development board D1 Mini with WiFi module ESP-8266MOD and 4 MB Flash memory. The module can be programmed from the Arduino IDE level. WeMos D1 Mini
zł18.24
24h
Available quantity: 54
Available
Development board D1 Mini V3 with WiFi module ESP-8266 and 4 MB Flash memory. The module can be programmed from the Arduino IDE level. WeMos D1 Mini V3.x
zł18.70
24h
Available quantity: 25
Available
WiFi module developed by AI-Thinker Co., Ltd with ESP8266 processor. Integrates a 32-bit MCU microcontroller with 80 MHz clock, RTOS support, Wi-Fi and antenna. The module supports the IEEE802.11 b / g / ni standard and has a complete TCP / IP protocol stack. AI-Thinker ESP-12S
zł9.29
24h
Available quantity: 37
Available
Transceiver module equipped with SoC ESP8285 IoT enabling communication with WiFi networks. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 113020011
zł71.75
24h
Available quantity: 1
Available
Development kit designed to support rapid prototyping and knowledge of Azure Sphere technology. Seeed Studio 102991099
zł490.84
24h
Available quantity: 3
Available
Board for applications in the area of the Internet of Things (IoT). The module is based on the ESP-WROOM-32E system with 240 MHz clock, equipped with 4 MB Flash and 520 KB SRAM, as well as WiFi and Bluetooth communication. DFRobot DFR0654
zł48.89
24h
Available quantity: 9
Available
Board for applications in the area of the Internet of Things (IoT). The module is based on the ESP-WROOM-32E system with 240 MHz clock, equipped with 4 MB Flash and 520 KB SRAM, as well as WiFi and Bluetooth communication. DFrobot DFR0654-F
zł53.96
24h
Available quantity: 3
Available
A small WiFi module designed for IoT applications. It can communicate with the motherboard via the I2C or UART interface. DFRobot TEL126
zł78.93
24h
Available quantity: 1
Available
The Wio RP2040 module is an advanced Wi-Fi chip designed for IoT projects. Equipped with a powerful Raspberry Pi RP2040 processor and an ESP8285 Wi-Fi chip, it provides stable wireless connectivity. It is compatible with popular programming environments such as C/C++ and MicroPython. SeeedStudio 102991556
zł43.98
24h
Available quantity: 3
Available
Powerful, generic Wi-Fi+BT+BLE MCU modules that target a wide variety of applications, ranging from low-power sensor networks to the most demanding tasks, such as voice encoding, music streaming and MP3 decoding. Espressif ESP32-WROOM-32E 32MBit (4MB)
zł19.08
24h
Available quantity: 10
Available
The expansion board (shield) with the DA16200 WiFi module. It is equipped with a Qwiic connector and is an excellent solution for IoT projects. SparkFun WRL-18567
zł105.42
24h
Available quantity: 2
Available
Function module designed for MicroMod boards. It allows you to add WiFi wireless communication based on the DA16200 chip to the project. SparkFun WRL-18594
zł161.66
24h
Available quantity: 1
Available
UART to Wi-Fi 802.11 b/g/n converter module with external antenna, which can connect traditional serial device and MCU controlled device to Wi-Fi network for control and management. USR-WIFI232-B2
zł49.09
24h
Available quantity: 9
Available
WiFi module based on ESP8266. It has an embedded antenna and 0.96 "OLED display. The module can be programmed in Lua (under NodeMCU firmware control) or in the Arduino IDE. Provides 12 GPIO lines.