

JTAG HS2
JTAG HS2 Programming Cable, Digilent, RoHS
The Joint Test Action Group (JTAG)-HS2 programming cable is a high-speed programming solution for Xilinx field-programmable gate arrays (FPGAs). The cable is fully compatible will all Xilinx tools and can be seamlessly driven from iMPACT, Chipscope, and EDK. The HS2 attaches to target boards using Digilent’s 6-pin, 100-mil spaced programming header or Xilinx’s 2x7, 2mm connector and the included adaptor. The PC powers the JTAG-HS2 through the USB port and will recognize it as a Digilent programming cable when connected to a PC, even if the cable is not attached to the target board. The HS2 has a separate Vdd pin to supply the JTAG signal buffers. The high speed 24mA three-state buffers allow target boards to drive the HS2 with signal voltages from 1.8V to 5V and bus speeds of up to 30MBit/sec. (See figure 1) To function correctly the HS2’s Vdd pin must be tied to the same voltage supply that drives the JTAG port on the FPGA. The JTAG bus can be shared with other devices as systems hold JTAG signals at high-impedance except when actively driven during programming. The HS2 comes included with a standard Type-A to Micro-USB cable that attaches to the end of the module opposite the system board connector. The system board connector should hold the small and light HS2 firmly in place.
![]() |
Features:
Download:
Code: 410-249
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
No product available!
No product available!
Compact programmer/debugger from Digilent, designed for use with Xilinx FPGA and SoC devices, including Zynq. With a USB 2.0 interface (up to 30 Mbit/s), power supply from a micro-B port, and full compatibility with Vivado, ISE, iMPACT, and EDK software, it provides convenient and reliable project support. Its design allows easy connection to boards with a 2x7 (2 mm) JTAG socket and sharing the bus with other devices. Digilent 410-299
No product available!
No product available!
XUP USB-JTAG Programming Cable (Academic)
USB compatible cable for in-circuit configuration and programming of all Xilinx devices
Module with Xilinx Artix-7 100T system, 32MB FLASH memory and very fast data transmission systems. Everything is on a small 4 x 5 cm plate. TE0741-03-160-2CF
No product available!
The JTAG-SMT3-NC module is a small, complete, surface-mounted Xilinx FPGA programmer board. It works with Xilinx takm software such as iMPACT, ChipScope ™, Vivado, and EDK. The module can be mounted on the main board as other components. Digilent 410-357
No product available!
No product available!
JTAG HS2 Programming Cable, Digilent, RoHS