Category: RETIRED PRODUCTS

MOD-39.Z

The STM32 eXploreM0 module contains a 32-bit microcontroller with ARM Cortex M0 core, STM32F051C8T6 (64 kB Flash memory, 8 kB RAM, 48 MHz, HDMI-CEC, I2C, IrDA, LIN, SPI, UART / USART). The USB / UART converter allows programming of the microcontroller via a USB cable. MOD-40.Z

The STM32 eXploreM0 + module contains a 32-bit microcontroller with ARM Cortex M0 + core, STM32L051C8T6 (64 kB of Flash memory, 8 kB RAM, 32 MHz, I2C, IrDA, SPI, UART / USART). The built-in USB / UART converter enables programming of the microcontroller via a USB cable. MOD-41.Z

MOD-44.Z

The RGB LED ruler has 8 programmable LEDs WS2812B with a built-in control system. It is possible to set a specific color for each diode. The module has an IN input for controlling and an OUT output to which further light points or other modules from WS2812B can be connected. The supply voltage is from 3.5 to 5.3 V, and the input voltage +/- 0.5 V of the supply voltage

V4 features the same sensors as v3 (L3GD20H, LSM303D) and adds an LPS25H digital barometer. An I²C interface accesses 10 independent measurements that can be used to calculate the sensor’s altitude and absolute orientation.

HK 69290

A 10-bit programmable magnetic object rotation sensor (encoder). It can work at 3.3V and 5V, it has a measurement resolution of 0.35 degrees and a serial and PWM signal output. The system has a SSOP16 housing

The 9DoF module allows measurements of acceleration, angular velocity and direction of the magnetic field. Communication with the system takes place via the I2C bus. modMPU9150 (GY-9150)

Roman Wantoch-Rekowski

Adafruit 2021

HK 55141

HK 55238

KA-NUCLEO-F411CE is a development board equipped with standard Arduino UNO connectors. Board is based on microcontroller STM32F411CE. The embedded programmer (compatible with ST-Link/V2-1) makes possible programming and debugging of microcontroller via USB connector.

DEV-13024

MOD-36.Z

Arduino M0 PRO (M0+ Atmel processor) with build in companion chip to let you debug your application

SATA line for Banana Pi only. Connects a 2.5 inch Hard Disk to your Banana Pi Computer

Aluminum Heat Sink for the Banana Pi CPU/GPU chip

This is an aluminum heat-sink for the Banana Pi RAM Chips. Run cool RAM chips with this little add-on. Just one heat-sink is needed to cover both RAM chips, use the picture below as reference. Signs of RAM or CPU overheating are computer stops responding, frozen screen and power shutt down or cycling.