Category: RETIRED PRODUCTS

Banana Pi R1 acrylic clear case. The case needs to be assembled by yourself

The housing for the Banner PI G1 Debugger made of transparent plastic. Housing for self-assembly

The I2C electric level conversion module is specifically designed for Banana Pi. The module converts the 3.3V of I2C electric level to 5V level or converts 5V to 3.3V

BPI AD/DA extend module with the PCF8591 single-chip, single-supply low-power 8-bit CMOS data acquisition device with four analog inputs, one analog output and a serial I2C-bus interface

Antena 3 DB do Banana Pi R1

5dB antenna for the Banana Pi R1 router in the version with 300Mps wifi and five LAN 100/1000 ports.

ZYBO Zynq™-7000 Development Board

Single-Chip HID USB to SMBus Master Bridge, QFN24, Silicon Labs, RoHS

PRT-10470

WRL-11216

WRL-11634

RN41XV is a small form factor, low power Bluetooth radio module offering plug-in compatibility for the widely used 2 x 10 (2mm) socket typically used for 802.15.4 radio modules. WRL-11600

The controller allows you to easily control the work of any device with the SPI interface via the USB port. All you need is a FTDI USB driver . TOL-09235

Battery: Li-Po; 3.7V; 2000mAh; Outputs: wires with 2-pin JST-PH connector; 5.8 mm x 54 x 60 mm. PRT-08483

PRT-09914 - JST Jumper 2 Wire Assembly

A single cell of a lithium-polymer battery, Sparkfun

Battery: Li-Po; 3.7V; 400mAh; Outputs: wires with 2-pin JST-PH connector; 5 x 25 x 35mm. PRT-10718

WRL-08742