Category: ELECTRONICS

GEMMA M0 is an intelligent clothing controller from Adafruit. In relation to the classic GEMMA board, it was equipped with a 32-bit ATSAMD21E18 microcontroller (based on Cortex M0 +). It has GPIO pins, RGB DotStar diode. The board can be powered by a 3.7 V Li-Ion battery (JST connector). Adafruit 3501

Development kit with STM32F103R8T6 microcontroller and 2.8 "TFT display with touch panel.

The Tic T825 USB Multi-Interface Stepper Motor Controller makes basic control of a stepper motor easy, with quick configuration over USB using our free software. The controller supports six control interfaces: USB, TTL serial, I²C, analog voltage (potentiometer), quadrature encoder, and hobby radio control (RC). 

Operational amplifier; 1,2MHz; 1.8 ... 6VDC; 2 channels; SOP8; Microchip, RoHS

Integrated circuit - temperature sensor; working temperature from -40 to 100 ° C; TO92; THT, STMicroelectronics. Accuracy ± 1 ° C

UV Sensor with response spectrum: 200nm-370nm

Seeed studio LoRa / GPS HAT is an extension designed for Raspberry Pi 2 minicomputers (model B) and Raspberry Pi 3. It has a LoRa communication module (868 MHz) and a GPS module. Seeed Studio 113990254

The GY-87 module is composed of a module with MPU6050, QMC5883L and BMP180 sensors, allowing the measurement of traffic in nine axes and the measurement of atmospheric pressure. The module has a built-in 3.3 V voltage stabilizer

LoRaWAN SX1303 module is equipped with a Mini-PCIe connector. It uses the SPI or I2C interface for communication. Waveshare SX1303 868M LoRaWAN Gateway (B)

NAND Flash 128MB (128x8) memory; TSOP-48; Winbond

The 30-core female-to-female connection wire with a length of 30 cm and a pitch of 2.54 mm provides reliable and flexible connections between modules and starter kits in DIY projects and prototypes

The 1.3 "LCD display and 168 x 144 pixel resolution is a combination of an e-ink display (e-paper) with LCD display, which is characterized by extremely low energy consumption by the eInk system and fast refresh of the LCD display. Adafruit 3502

32-bit microcontroller with ARM Cortex-M4 core, Ultra-low-power, 144 pins, 1 MB Flash, 320 KB SRAM, temperature range -40 ... 85 ° C, LQFP144, STMicroelectronics, RoHS

LCD touch screen with 160x128 pixel resolution, LCD160CR (I2C or UART and SPI) display controller. Adafruit 3498

Pin header, 20 pin, 2,54mm

Bluetooth module with built-in CC2541 chip. The module is small, energy-saving and easy to use

A module with a temperature sensor based on the absorption of infrared radiation. Enables non-contact measurement. modTMP006

The LoRaWAN SX1302 module is equipped with a Mini-PCIe connector. It uses the SPI or I2C interface for communication. Waveshare SX1302 868M LoRaWAN Gateway (B)

Black and white e-Paper display with a diagonal of 3.52" and a resolution of 360x240 px. Communicates via the SPI interface. Without a PCB. Waveshare 3.52inch e-Paper

DFRobot SEN0153