Category: Electronic modules

Compact module with MOSFET IRF520 24V/5A transistor.

3.3V Power Supply Module Board with Red Indicators, AMS1117-3.3V, RoHS

5.0V Power Supply Module Board with Red Indicators, AMS1117-5.0V, RoHS

USB-RS485 converter for industrial applications. It provides communication between the USB interface and the RS485 serial standard. Waveshare USB TO RS485 (B)

UART-CAN converter module based on the TJA1050 transceiver system. It allows for communication, for example, of a microcontroller via the CAN bus

150 W Step-Up converter with an output voltage of 15to 35 V, an input voltage of 10 to 32 V and a maximum current of up to 6 A

Module with a 12 V relay and a timer. It allows you to turn the device on and off cyclically at a specified time using potentiometers. It can also operate in single trigger mode, which allows the device to be turned on after a signal has been applied for a specified period of time. The operating time can be adjusted from 1 s to 100 s or from 1 s to 15 min

Frequency generator module with Si5351 chip based on 25 MHz quartz. The system has three independent, programmable clock outputs that can generate a clock signal in a wide range from 8 kHz to 160 MHz

Module of a stereo 24-bit audio converter with I2S interface (TS4657).

Adjustable proximity sensor E18-D80NK allows detection of the object at a distance of 3 - 80 cm. Detection of an obstacle occurs due to the appearance of reflected infrared light.

Step-Down converter module with input voltage from 4.75 to 23V, output voltage from 1 to 17V and output current 1.8 A (3 A instantaneous current).

DS18B20 compatible temperature sensor in a waterproof stainless steel housing, RoHS

Bluetooth audio receiver module that allows wireless transmission of sounds. It is equipped with a PCB antenna and a 3.5 mm Jack audio connector

Breadboard power supply module, 5V, 3.3V, RoHS

The module is equipped with an AS5600 magnetic encoder with a resolution of 12-bit. It allows for non-contact measurement of the angle of rotation. The module has an analog/PWM output and an I2C interface.

Compact expansion module compatible with DRV8825 and A4988 stepper motor drivers. It allows you to connect the module with the controller and convenient connection of other system components

The base plate is dedicated to ESP32 CAM modules. It allows you to connect the camera via a USB interface, e.g. to a computer. ESP32-CAM-MB

DRV8825 Stepper Motor Driver Carrier is a DRV8825 stepper motor driver that allows you to supply a bipolar current of up to 1.5 A per phase, without using a heat sink. The system can be supplied with voltage up to 45V, in the set there is a heat sink. It is compatible with Polol 2133

Step-Up/Step-Down converter with an output voltage of 3.3 V, an input voltage from 3 to 15 V and a maximum current of up to 600 mA

Step-Up converter with adjustable output voltage from 5 to 40 V, input voltage from 3 to 35 V and a maximum current of 5 A