ESP32-CAM-MB - base board for ESP32-CAM

Module with MOSFET transistor, 5-36 V, 20 A, switching frequency 1 kHz. DFRobot DFR0457

Lens with M12 mount. It has a focal length of 25mm and a FoV of 20.2°. It is designed to work with the Raspberry Pi HQ M12 camera. Waveshare WS0202505

This BLDC motor controller, based on the Allegro A89301 chip, enables sensorless control over a wide voltage range from 5.5 V to 48 V and phase current up to 11 A without additional cooling. It supports four control modes: analog voltage, PWM signal, pulse frequency, and via an I²C interface with the ability to configure parameters and save settings to EEPROM. The Field-Oriented Control (FOC) algorithm ensures quiet and efficient operation, while built-in protection protects the system against short circuits, reverse polarity, and undervoltage. Pololu 5357

Unshielded UTP category 5E Ethernet network cable with RJ45 plugs. Lanberg PCU5-10CC-0300-BK

GOODRAM UME3 128 GB is an efficient and capacious flash drive for everyday use, combining good transfer speed with high reliability and an attractive price.

The MPI-01 miniature industrial relay ensures high reliability and functionality, meeting the requirements of industrial insulation and safety standards. Finder 55.34.8.230.0040

A synchronous step-down converter that reduces input voltage from 5V to 60V to a stable 5V with up to 95% efficiency and up to 6A output current. It offers low standby current (<0.2mA), soft-start functionality, overcurrent, thermal, and reverse polarity protection. Compact and easy to integrate, it is ideal for microprocessor systems, IoT, and automation. Pololu 5571

Set of bullet terminals with insulation for wires from 0.5 to 1.5 mm². The box contains 50 male and 50 female connectors in five colors: black, red, green, yellow and blue.

A sensor that detects the concentration of sulfur dioxide. Equipped with a factory calibrated probe. It communicates via the I2C interface, UART or analog output. DFRobot SEN0470

L7805CV, +5V voltage regulator, 1.5A, TO220, STM, RoHS

KAmodHTS221 is a module that allows the measurement of humidity and temperature, and thanks to the built-in stabilizer and translator levels, it can be successfully used in systems supplied with a voltage of 2.5 - 5.5 V

White warm LED strip with SMD 5050 diodes. It is powered by 12 V DC, has a length of 5 m and 60 LEDs/m. Protection level IP21

Uninterruptible power supply (UPS) module allowing continued operation and safe shutdown after a power failure. It provides an output voltage of 5 V and allows the reading of battery operating parameters via the I2C bus. Waveshare UPS Module Mini