Category: Motor controllers
There are 314 products.
No product available!
Pololu High-Power Motor Driver 18v15
No product available!
Dual MC33926 Motor Driver CarrierTwo-channel DC motor controller with voltage from 5 V to 28 V, power consumption up to 3 A per channel. Controlled by PWM signal. Pololu 1213
No product available!
No product available!
Pololu Simple High-Power Motor Controller 24v23
No product available!
Pololu Simple Motor Controller 18v7
No product available!
Pololu Simple High-Power Motor Controller 24v12
No product available!
This shield makes it easy to control two high-power DC motors with your Arduino or Arduino-compatible board. Its dual robust VNH5019 motor drivers operate from 5.5 to 24 V and can deliver a continuous 12 A (30 A peak) per motor, or a continuous 24 A (60 A peak) to a single motor connected to both channels. Pololu 2507
No product available!
Pololu Simple High-Power Motor Controller 18v25
No product available!
Pololu High-Power Motor Driver 24v23 CS
No product available!
Pololu Jrk 21v3 USB Motor Controller with Feedback
No product available!
No product available!
No product available!
No product available!
This Kit with fully-dedicated PWM driver chip handles all the motor and speed controls over I2C. Only two data pins (SDA & SCL in addition to the power pins GND & 5V) are required to drive the multiple motors; you can also connect any other I2C devices or shields to the same pins. This makes it drop-in compatible with any Arduino, such as the Uno, Due, Leonardo and Mega R3. Adafruit 1438
No product available!
TB9051FTG Single Brushed The DC Motor Driver Carrier is a single DC motor driver that allows the motor to be supplied with voltage in the 4.5 ... 28V range and power consumption at a continuous 2.6 A (5A peak) operation. Pololu 2997
No product available!
Stepper motor driver with MP6500 system with a potentiometer for current regulation. It allows the bipolar motor to be supplied with current up to 1.5A per phase without the use of a heat sink. Pololu 2967
No product available!
DC motor driver that allows you to control the movement of two drives using the I2C interface. Board with soldered connectors. Pololu 5040
No product available!
Extension module with a driver for two stepper motors based on the HR8825 system. Dedicated for Raspberry Pi minicomputers. Waveshare Stepper Motor HAT (B)
No product available!
DC motor driver that allows you to control the movement of three drives using the I2C interface. The set includes only the board without connectors. Pololu 5032
No product available!