Best sellers

Bipolar stepper motor. It has a resolution of 200 steps/revolution (1.8 ° per step), has a nominal voltage of 7.4 V, and draws a current of 0.28 A per coil. Pololu 1207

1.5 hPa resolution pressure sensor from Freescale. The sensor is soldered onto a PCB with 10K pull-up resistors on the I2C pins. Adafruit 992

Module with a magnetic sensor based on a reed switch. Reacts to the action of an electromagnet or a permanent magnet

A set of 5 modules with a button and LED backlight. The boards are equipped with a Gravity connector and communicate via a digital interface. DFRobot DFR0785

A set of test leads 2x4 (4 signal and 4 GND) with a length of 23cm and 22AWG intended for logic analyzers Saleae.

Pre-installed Android 4.x or latest version. eMMC Version 5.0 interface or higher version from Samsung.
JEDEC/MMCA version 5.0 : HS400 interface with 8bit DDR mode

K type blade, bevelled knife 8mm for WEP 926 soldering station. Used for soldering in narrow places

A set of test leads 2x4 (4 signal and 4 GND) with a length of 23cm and 22AWG intended for logic analyzers Saleae

Digital shock sensor with spring type vibration switch. It detects vibrations and signals them via a digital output

Patchcord UTP 5E Ethernet cable with a length of 3 m - blue, with 2xRJ45 connectors

4D drone in a set with four-channel remote control equipment for the 2.4 GHz band; allows you to quickly and safely master the technique of quadrocopter flying, and thanks to the six-axis detection, the position behaves stably and allows you to perform complicated tricks. JD-385

This gearmotor is a miniature medium-power, 6 V brushed DC motor with a 297.92:1 metal gearbox. It has a cross section of 10 × 12 mm, and the D-shaped gearbox output shaft is 9 mm long and 3 mm in diameter. This version also has a 4.5 × 1 mm extended motor shaft.

IoT development board with STM32WLE5JC chip that connects the microcontroller with the ARM Cortex-M4 core and the LoRa SX126X module. It has all the pins of the LoRa-E5 module and an external antenna. Seeed Studio 113990939

Miniature, 12V brush DC motor with metal gear with 15.25: 1 ratio. It has a cross section of 10 × 12 mm, and the D-shaped output shaft has a length of 9 mm and a diameter of 3 mm. It also has an extended motor shaft with dimensions of 4.5 × 1 mm. Pololu 4789

Module with active low-pass filter. Dedicated to the bass column (subwoofer)

80 W audio signal converter that reduces the speaker signal from the player to the level of RCA inputs. It allows you to connect to an external power amplifier. TSK TD-22

Non-contact liquid level sensor. It allows you to detect the presence of, among others water in non-metallic containers. DFRobot SEN0368

Double comparator with low power consumption in the TSSOP-8 housing. STMicroelectronics LM2903YPT