Best sellers

Pi5 Module BOX-A is a complete enclosure and expansion solution for the Raspberry Pi 5, adding a Gigabit Ethernet interface via PCIe. With its robust aluminum construction, flexible mounting options, and support for accessories and additional HATs, the kit is ideal for demanding networking, server, industrial, and educational applications.

The 13.56 MHz RFID reader module in a set with a keyring and RFID card

SEN-12829

Pololu - 1502

GY-9250 is a 9 Degrees of Freedom (9DoF) module with the InvenSense MPU-9250 chip. It has a built-in gyroscope, accelerometer and magnetometer.

modTSL2561 is a module containing a light sensor TSL2561; communication with the system takes place using the I2C bus

Hybrid bipolar stepping motor with integrated 38cm (15″) threaded rod as its output shaft, turning it into a linear actuator capable of precision open-loop positioning. The motor has a 1.8° step angle (200 steps/revolution) and each phase draws 1.7A at 2.8V, allowing for a holding torque of 3.7kg-cm (51 oz-in). Pololu 2690

M5Stack A131 is a single-port TTL–RS485 converter with built-in 12 V power supply, enabling reliable RS485 communication and powering of M5ATOM devices in compact embedded systems and industrial automation applications.

The module allows measuring the light around the sensor. The measuring range is in the range 1 - 65535 LUX, and communication takes place using the I2C bus. modBH1750 (GY-302)

Dual Full-Bridge Driver, Power SO20, STM, RoHS

The UBIQUITI UniFi Switch Flex Mini is a five-port Gigabit Ethernet switch powered via PoE or USB-C, designed for installations in UniFi systems that require simple and reliable LAN network expansion. With support for Jumbo frames, Full Duplex transmission, and compact dimensions, it is suitable for office, industrial, and home environments.

Arduino Starter Kit with Uno board

The UBIQUITI UniFi UX access point, featuring a weather-resistant design, supports Wi-Fi 6 and earlier wireless standards, enabling speeds of up to 2.4 Gb/s. It is equipped with two Gigabit Ethernet ports, an internal antenna, Bluetooth and Wi-Fi interfaces, as well as advanced WPA3 security. It is used in outdoor installations requiring high performance and reliability, both in private and commercial sectors.

This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 9 V. The board measures only 0.7″ × 0.7″, but it allows a typical continuous output current of up to 2.5 A. Typical efficiencies of 85% to 95% make this regulator well suited for powering moderate loads like sensors or small motors.

A set of adapters (adapter) from the motor shaft 6 mm to 12 mm, wheel holders from RC models. Pololu 2687

The Pololu A-Star 32U4 Prime is a general-purpose programmable board based on Atmel’s ATmega32U4 AVR microcontroller and arranged in the common Arduino form factor exemplified by the Uno R3 and Leonardo. Pololu 3114

Translator of TI voltage levels, bidirectional (no signal required to control the flow direction), 8-Bit, especially recommended for use in Push-Pull and Open-Drain systems. The system has a TSSOP20 housing

Aluminum extensometer beam, allowing measurement of weight up to 20 kilograms. It has four wires. It is used in kitchen scales and portable scales, it has a 21 cm cable, RoHS.

Tilt Sensor

USB-C to 3.5 mm Jack Adapter with DAC Converter is a practical solution for smartphone users without a traditional audio output. It provides high sound quality, full microphone functionality, and seamless Plug & Play operation. Ideal for everyday music listening, watching movies, or making voice calls.