modRFID RC-522 - 13.56 MHz RFID reader

NFC module designed for Arduino. Meets the standards of reader mode, P2P mode and card emulation mode. The board has an integrated RF antenna. NXP OM5578/PN7150ARDM

M5Stack U107 is an evaluation board with an RF transceiver operating in the 840 MHz - 960 MHz band, designed for wireless communication in IoT systems. Thanks to its wide frequency range, this module is suitable for applications such as smart cities, remote measurements and security systems

Intelligent RFID identifier cooperating with iNode Control Point

Module with an RFID reader designed to work with the Raspberry Pi. Equipped with an OLED display and a buzzer. SB Components 20003

Intelligent RFID identifier cooperating with iNode Control Point

The dynamic NFC / RFID tag with I2C bus and ISO 15693 RF interface in the SOIC8 housing has a built-in 64k EEPROM memory. Producer: STMicroelectronics

Adapter for RFID reader (125 kHz). Works with ID-3LA, ID-12LA and ID-20LA series systems. SparkFun SEN-13030

Module with an RFID tag based on the ST25DV16K chip. It can be reprogrammed via the I2C bus. Equipped with STEMMA QT connector and PCB antenna. Adafruit 4701

Handheld RFID card reader enabling card duplication. It allows you to read data from one card and write it to the other

UHF RFID module (EPCglobal Gen 2), based on JADAK\'s M7E-HECTO chip, which enables fast reading of up to 300 tags per second and writing in 80 milliseconds, with adjustable output power from 0 dBm to 27 dBm. Equipped with a USB-C connector and CH340C converter, the module enables easy connection to a computer, and thanks to support for power supply via USB-C or 3.3V connector with a pitch of 2.54 mm, it is compatible with both computers and microcontrollers, providing flexible use options. SparkFun WRL-24738

Card with RFID tag for systems operating at 125 KHz. Provides the ability to read and write the ID number

The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away. These can be read by almost any 13.56MHz RFID/NFC reader. Adafruit 360

A set of RFID tags consisting of three key rings in different colors and two white cards. The tags operate at 125 kHz and comply with the EM4100 standard. Seeed Studio 110990035

NFC/RFID tag equipped with ST25DV64KC NFC/RFID tag from STMicroelectronics. The chip offers a 64-kbit (8-byte) EEPROM. Complies with ISO/IEC 15693 or NFC Forum Type 5. SparkFun SEN-21274

RFID tag for systems operating at 125 KHz. Provides the ability to read and write a unique ID number

The RFID / NFC transponder reader module (tags) works in the PN532 chip and is compatible with Arduino. Data is available via SPI, I2C or HSU (High Speed UART). Supplied with a RFID card and key ring. ELECHOUSE NFC MODULE V3