Best sellers
There are 17461 products.
Module with Sensirion SCD30 sensor, which enables CO2, temperature and humidity measurement. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020634
Hermetic enclosure Z116 lightgray with gasket
I/O pin expander designed for Arduino platforms. Provides 48 connections to increase the number of analog inputs, digital inputs and digital outputs. SparkFun DEV-11723
LM386 audio amplifier module in a set with a loudspeaker. The board is equipped with a Grove connector and is controlled by a PWM signal. Seeed Studio 101020853
2.1-channel 40-watt high-efficiency digital audio system Sound Terminal, PowerSSO-36, STM, RoHS
Doppler radar module with 24GHz BGT24LTR11 transceiver. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 109020021
USB / USB type C cable with a long 0.8m long connector. Kruger & Matz KM0363
Raspberry Pi computer support rails compatible with Raspberry Pi A +, B +, B2, B3 models.
The X-NUCLEO-IHM15A1 dual brush DC motor driver expansion board is based on the STSPIN840 for STM32 Nucleo. It provides an affordable and easy-to-use solution for the implementation of compact motor driving applications such as thermal printers, robotics and toys
Module with WiFi Espressif ESP32. It offers 8MB Flash, 2MB PSRAM, LiPo charging circuit and RGB LED. It is equipped with a STEMMA QT connector. Adafruit 5438
Module with GNSS PA1616D receiver based on the MTK3333 chip. Supports GPS and GLONASS positioning systems. Adafruit 5440
The X-NUCLEO-IHM16M1 motor driver expansion board is based on the STSPIN830 monolithic driver for three-phase brushless motors. It represents an affordable, easy-to-use solution for driving brushless motors in your STM32 Nucleo project, implementing single and three-shunt current sensing
Dual DC motor controller designed for Arduino, which enables the motor to be supplied with voltage in the 4.5 ... 28V range and power consumption in continuous operation of 2.6 A (5A at the top) of two DC motors. Polol 2520
4-pin cable with JST SH connector compliant with STEMMA QT/Qwiic. Ended with alligator clips. Adafruit 4398
Aluminum tape, 20 m long and 2 cm wide. It is used to protect components during soldering with hot air
KKMulticopter v5.5 flight controller designed for multirotor constructions such as quadcopters, tricopters or hexacopters. The board is based on the ATmega168 microcontroller and equipped with three ENC-03-RC gyroscopes providing stabilization in three axes. The set includes the controller, a power board and a programmer enabling firmware uploading.
DC motor driver that allows you to control the movement of three drives using the I2C interface. Board with soldered connectors. Pololu 5033
Espruino module with Bluetooth LE based on MDBT42Q system with Nordic Semiconductor nRF52832 microcontroller. The module has a pre-installed JavaScript interpreter. Adafruit 3876