New products
New products New products
Best sellers
There are 16544 products.
32-bit microcontroller from the STM32L4 family (low power series) with ARM Cortex-M4 core, 1MB Flash memory, 320kB RAM, clock speed up to 80MHz and I2C, SPI, UART / USART interfaces, USB OTG, CAN, LIN, IrDA, I2S , DMA, Motor Control PWM, Temp Sensor, WDT, A / D 10x12b in the LQFP64 housing. STMicroelectronics STM32L496RGT6
Permanent cylindrical neodymium magnet with a diameter of 15 mm and a height of 1 mm. Set of 10 pcs
The most popular Sn60Pb40 SW26 solder is a high-quality lead product with SW26 flux, intended for professional soldering in electronics and electrical engineering, meeting the EN ISO 9453:2014 standard
The WAGO 221-613 connector is a compact, three-wire installation terminal with levers, enabling quick and secure connection of wires with cross-sections ranging from 0.5 mm² to 6 mm² (20–10 AWG). The transparent housing allows for visual inspection of connections, while the compact design facilitates installation in confined spaces.
Momentary button with a diameter of 12 mm and a height of 21 mm. White colour
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and an output in the form of pads. Allows powering devices with 15V. PDC004
Set of 10 pieces hex nuts M2.5 (white galvanized)
Cabel USB Mini-USB-A 2.0 1,8m Black Lanberg CA-USBK-10CC-0018-BK
Neodymium rectangular magnet with dimensions of 20x10mm a and a height of 5 mm. Set of 5 pcs
ITO (Indium Tin Oxide) coated square glass, electrically conductive. It measures 5cm x 5cm, thickness 1.1mm and resistance 15 Ohm per square inch. It can be used, among others in capacitive sensors (eg touch button), or in external devices (eg automatically evaporating camera glass)
BMS module for two 7.4V lithium cells. Charging, discharging and over-discharge protection. The cells can be charged with a continuous current of up to 20 A
Angled male socket, wire-board type, for JST PH-2.0 wires, 8-pin, 2mm pitch, 100V, 2A. Set of 10 pieces
The SUNON 40x40x20mm axial fan is a reliable and quiet cooling device, with an efficiency of 9.3m³/h, power consumption of 0.38W, operating at a voltage of 4.5-13.8V, equipped with Vapo bearings and a brushless DC motor, emitting only 12.3dBA noise. Sunon HA40201V4-1000U-A99
Female terminal block, 6-pin. Pitch 3.81mm. Height 7.8mm. Suitable for 15EDGRC male strips with a pitch of 3.81 mm. 2EDGKN-3.81
Development kit with STM32L496ZGT6 microcontroller (ARM Cortex-M4 core) with a built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone, Arduino connector
The YT-08295 magnetic bowl, with a diameter of 110 mm, is made of stainless steel. Equipped with a strong magnet, it helps keep your workspace organized. The base is covered with a rubber pad to protect surfaces such as car paint. YT-08295
Shielded FTP category 5E Ethernet network cable with RJ45 plugs. Lanberg PCF5-10CC-0150-S
Tact switch button with dimensions 3x7x3.5mm, designed for surface mounting. Set of 10 pieces