New products
New products New products
Best sellers
There are 16641 products.
UV Sensor with response spectrum: 200nm-370nm
Gravity module with a fingerprint reader (capacitive sensor). It uses an efficient processor and the IDfinger6.0 algorithm. It ensures quick identification and stability of operation, communicates via the I2C interface. DFRobot SEN0359
LIDAR distance sensor with a measuring range from 5 cm to 10 m and a resolution of 1 cm. It communicates via the I2C or ANT interface. SparkFun SEN-15776
BME280 integrates onboard temperature sensor, humidity sensor and barometer. It provides both SPI and I2C interfaces; and can be widely used in environmental monitoring, story height measurement and Internet of Things (IoT) control and so on. SEN0236
Module with LCD display dedicated to Arduino boards. Equipped with a joystick and Gravity connectors. DFRobot DFR0287
Module with SHT31 temperature and humidity sensor. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020212
Extension module with terminal blocks compatible with Arduino Uno connectors. DFRobot DFR0224
The S9V11F5 switching step-up/step-down regulator efficiently produces 5V from input voltages between 2V and 16V. Pololu 2836
IPS LCD display 7" with a resolution of 1024x600 px with a touch panel. It uses the eDP interface and is compatible with LattePanda Alpha and Delta. DFRobot FIT0551
The board is equipped with ATSAMD21 microcontroller with ARM Cortex-M0 core and SPI Flash memory, GPIO pins and RGB diode. Adafruit 3505
Ambient light sensor placed in a transparent hemisphere. It supports a detection range of 0 to 200 klx and communicates via the I2C interface. DFRobot SEN0390
Sound recording module that can store sounds up to 40 minutes long. It allows you to download the recordings to a computer via USB type C. DFRobot DFR0745
Adafruit HUZZAH32 is a development board with a built-in WiFi ESP32 module. Processor frequency: 240 MHz, Li-Pol battery charging system. Adafruit 3405
Adapter for PS2 (female) connector. The connector is pre-soldered on the PCB. The pins have a 2.54 mm pitch, which facilitates their installation on the breadboard. Cytron Breakout Board PS2 Connector
EXTREME heat shrink tubing for electrical and mechanical insulation, diameter against shrinkage 8.0mm; diameter after shrinkage 4.0 mm, a set of 10 pieces with a length of 1 meter
Evaluation board with ATSAMD21 microcontroller with ARM Cortex M0 core. Equipped with motion, temperature, light, sound sensors and RGB diodes. Can be programmed in MakeCode, CircuitPython, Arduino IDE or CS Discoveries. Adafruit 3333
Nano I / O Shield for Arduino Nano is an expansion board for Arduino Nano that provides digital, analog pins, power inputs and a connector for the Bluetooth module. DFRobot DFR0012
Evaluation Kit with Bluetooth 5.0 BT401. It is equipped with a microSD slot, microUSB connector and two audio outputs. DFRobot DFR0782
Kit for building an intelligent JetBot robot based on Jetson Nano. It consists of an expansion module, camera with Sony IMX219 image sensor, motors, housing and a set of mounting screws. Waveshare JetBot 2GB AI Kit Acce
The expansion module is designed to work with a portable computer built into the Raspberry Pi 400 keyboard. The board has a 40-pin connector in a vertical position. Waveshare PI400-GPIO-ADAPTER-A